Loading ...
Loading ...
Loading ...
en Installation and connection
48
Drinking water connection
1. Fasten the drinking water connection
to the tap according
to the installation instructions using
the enclosed parts.
Ensure that the drinking water
connection is not kinked, crushed
or twisted.
2. When replacing the appliance,
always use a new water supply
hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1
MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.
Warm water connection*
Ho t wa t e r c onnect i on
* depending on the configuration of
your specific dishwasher
The dishwasher can be connected to
cold or hot water up to max. 60°C.
Connection to hot water is
recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with
circulation line. This will save energy
and time. The hot water setting ‘:‹‚
allows you to adjust your appliance
optimally to operation with hot water. It
is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C and
no more than 60 °C. It is not
recommended to connect the appliance
to hot water if the water is supplied from
an electric boiler.
Here’s how to change the hot water
setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display h lights up
to show the value •:‹....
4. Press the programme button #
repeatedly until the factory setting
value ‘:‹‹ appears in the display
window h.
5. By pressing the 3 button, you can
switch the hot water setting off ‘:‹‹
or on ‘:‹‚.
6. Press START button `.
The set value is saved.
Loading ...
Loading ...