Loading ...
Loading ...
Loading ...
en Fault, what to do?
38
Fault code “:ƒ… is lit. Waste-water hose kinked or
blocked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the waste water pump
loose.
Lock cover correctly. ~ "Waste water
pump" on page 36
Fault code “:ƒ† is lit. Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Clean pump and lock cover correctly.
~ "Waste water pump" on page 36
Fault code “:ƒˆ is lit. Mains voltage too low. No appliance fault, have the mains voltage
and electrical installation checked.
A different fault code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off the appliance with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off water supply
and pull out the mains plug.
Call customer service and quote the fault
code.
p or • appears on the
digital display h. *
Not a fault! See turboSpeed 20 min. in the chapter
“Overview of programmes”. *
Refill indicator for salt @
and/or rinse aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt @
and/or rinse aid H is not
lit.
Refill indicator switched off. Activation/deactivation (see chapter
“Water softening system/Special salt”
~ Page 13 or “Rinse aid” ~ Page 15).
There is still enough special
salt/rinse aid available.
Check refill indicator, levels.
The Machine Care display
lights up. *
Machine Care is recommended. Run the Machine Care programme using a
special dishwasher cleaning agent and
without loading any utensils.
The display will go out automatically after
three wash cycles whether or not the
Machine Care programme is carried out.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1Z is blocked.
Clean filters and area underneath.
Programme has not yet finished Wait until programme ends or reset.
Fault Reason Remedial action
* depending on the configuration of your specific dishwasher
Loading ...
Loading ...
Loading ...