Loading ...
Loading ...
Loading ...
Setting Up _9
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of
the appliance. By completing the following steps, your Refriger ator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled
and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store
food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessory list below
01
Water filter
(DA29-00003B)
Hex wrench
(DA80-00002C)
Compressin fitting
(DA62-00305A)
Compression nut
(DA74-00070B)
. See Controlling the Temperature Section (Page 23).
5. Assembly the water line to the refrigerator and verify that the couples are correctly assembled without
water leakage.
COMPONENTS FOR HANDLE ASSEMBLY
[ 3-DOOR TYPE ]
Wrench : 3/32 inch
Label Handle Instruction
Fridge
Freezer
HOW TO ASSEMBLE THE HANDLE
Fridge door handle assembly
OKOK
By using L-wrench, Fix the screw with the Longer part of it and
then fully tighten up with the Shorter part.
To best conceal the connection
points : Assemble the handles
with the mounting screws facing
each other.
the screw and then put the handle
Fastener
(DA60-00143B)
(Optional)
Loading ...
Loading ...
Loading ...