Loading ...
Loading ...
8
the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
FILLING THE WATER TANK
1. Extract the tank by pulling it upwards (g. 1).
2. Open the lid and ll the tank with fresh clean water, taking
care not to exceed the MAX level (g. 2).
Put the tank back in the appliance, pressing lightly to open
the valves located on the bottom of the tank.
3. More simply, the tank can also be lled without extracting
it by pouring the water directly from a jug.
Important:
Never operate the appliance without water in the tank or
without the tank.
Please note:
It is normal for there to be water in the space under the tank.
This should therefore be dried regularly with a clean sponge.
SETTING UP THE APPLIANCE
• Turn the appliance on by pressing the ON/OFF switch (g.
3). The appliance performs a self-diagnosis cycle, indicated
by sequential ashing of the three buttons.
• The
and lights ash to indicate the appliance
is heating up.
When the lights stop ashing and remain on steadily, the
appliance is ready for use.
• Place a container with a minimum capacity of 100 ml
under the hot water/steam spout (g. 4).
• Turn the hot water/steam dial to the
position (g.
5) and deliver about 100 ml of water, then close the dial
again (○ symbol).
• Attach the lter holder to the appliance. To attach correctly,
align the lter holder handle with the INSERT symbol (g.
9), attach the lter holder and rotate the handle towards
the right until aligned with the CLOSE symbol.
•
To rinse the machine’s internal circuits, place a con-
tainer under the coee spout and press the
key. Repeat this procedure 5 times.
• Then proceed with rinsing the “steam” circuit: place
a container under the hot water spout and turn the
dial to the position. Hot water is delivered.
When the appliance automatically stops the hot
water delivery, close the dial (○symbol). Repeat this
procedure 1 more time (If necessary, rell the tank).
Please note:
The rst time you use the coee maker, you need to make
4/5 cups of coee or 4/5 cappuccinos before it starts to give
satisfactory results.
PROGRAMMING THE SETTINGS MENU
To access the menu, make sure the appliance is ready for use,
then press and hold the
button for 10 seconds until the
three buttons ash in sequence:
The appliance is now in programming mode.
Set the coee maker as you wish, then exit the settings menu by
waiting for 15 seconds.
Please note:
If no selections are made for 15 seconds, the appliance
automatically exits programming and is ready for use again.
Setting coee temperature
To modify the temperature of the water used to make the coee,
proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the coee temperature
selection mode.
The lights corresponding to the current selection come on:
low
medium
high
3. The lights start ashing in sequence;
4. Press the button corresponding to the required
temperature:
low medium high
5. The button
ashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
Setting water hardness
The light (V2) indicating that the appliance needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the
hardness of the mains water in the various regions so that
descaling needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
Loading ...
Loading ...
Loading ...