Loading ...
Loading ...
Loading ...
ENGLISH
• 11 •
ENGLISH
Note: The machine is ready when the brew button
light (16) is permanently on.
Note: If it is not possible to dispense a
cappuccino as described, prime the circuit as
explained in section 4.5 and then repeat the steps.
The same process can be used to heat other
beverages.
• After this operation, clean the steam wand with a wet
cloth.
9 CLEANING
Maintenance and cleaning operations may only be
carried out when the machine has cooled down and has
been disconnected from the power supply.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and lling it up
with fresh water daily.
• (Fig.21-22) - Every day, after heating the milk, remove
the external part of the Pannarello and wash it with fresh
drinking water.
• (Fig.23) - The steam wand should be cleaned every week.
In order to do this operation, you have to:
- remove the external part of the Pannarello (for standard
cleaning);
- loosen the ring nut (without removing it);
- remove the upper part of the Pannarello from the steam
wand;
- wash the upper part of the Pannarello with fresh drinking
water;
- wash the steam wand with a wet cloth and remove any
milk residue;
- replace the upper part of the steam wand (make sure
it is completely inserted);
- tighten the ring nut.
Reassemble the external part of the Pannarello.
• (Fig.24) - Empty and clean the drip tray every day.
• Use a soft cloth damp cloth to clean the appliance.
• (Fig.17) - To clean the portalter proceed as follows:
- remove the lter, wash it thoroughly with hot water.
- remove the adapter (if tted), wash it thoroughly with
hot water.
- wash the internal part of the portalter.
• Do not dry the machine and/or its components using a
microwave and/or conventional oven.
Once descaling has been performed (see section 10), the
brew unit lter and the gasket should be cleaned.
To clean the lter, proceed as follows:
• Loosen the screw xing the lter to the brew unit by means
of the screwdriver which is supplied with the scraper.
• Remove the lter and wash it thoroughly with a neutral
detergent.
• Rinse and reinstall the lter; fasten the screw by means
of the screwdriver which is supplied with the scraper.
To clean the gasket, proceed as follows:
• insert the scraper into the brew unit as shown;
Loading ...
Loading ...
Loading ...