Loading ...
Loading ...
Loading ...
4
NOTE
The exterior walls of the unit may become
quite warm as the compressor works to
transfer heat from the inside. Temperatures
as much as 30° F warmer than room
temperature can be expected. For this reason
it is particularly important in hotter climates to
allow enough space for air circulation around
your appliance.
NOTE
It is very important for your appliance to be
level in order to function properly. If the unit
is not leveled during installation, the door may
be misaligned and not close or seal properly,
causing cooling, frost, or moisture problems.
Leveling
The appliance must have all bottom corners
resting rmly on a solid oor. The oor must be
strong enough to support a fully loaded unit.
This Use & Care Guide provides general operating
instructions for your model. Use the unit only
as instructed in this Use & Care Guide. Before
starting the unit, follow these important
rst steps.
Cleaning
Wash any removable parts of the appliance
interior and exterior with mild detergent and
warm water. Wipe dry. DO NOT USE HARSH
CLEANERS ON THESE SURFACES.
Location
Choose a place that is near a grounded
electrical outlet.
For the most efcient operation, the appliance
should be located where surrounding
temperatures will not exceed 110°F (43°C).
The Freeze Control Feature is designed to
automatically maintain the selected interior
temperature within these boundaries.
Allow space around the unit for good air
circulation. Leave a 3 inch (75 mm) space on
all sides of the unit for adequate circulation.
CAUTION
To allow door to close and seal properly, DO
NOT let food packages extend past the front
of shelves.
To Level Your Appliance:
After discarding crating screws, use a
carpenter’s level to level the unit from front-to-
back. Adjust the plastic leveling feet in front,
½ bubble higher, so that the door closes easily
when left halfway open.
3” (75 mm)
3” (75 mm)
3” (75 mm) Air Space
3” (75 mm)
To install the shelf grommet to the shelf:
1. With the wire shelf installed, press the
shelf grommet down onto the wire that
is anchored into the appliance wall. Be
sure to keep the larger end of the shelf
grommet away from the wall.
Do not use razor blades or other sharp
instruments which can scratch the appliance
surface when removing adhesive labels. Any
glue left from the tape can be removed with a
mixture of warm water and mild detergent or
the residue can be touched with the sticky side
of tape already removed. DO NOT REMOVE
THE SERIAL PLATE.
FIRST STEPS
Loading ...
Loading ...
Loading ...