Loading ...
Loading ...
Loading ...
6
A-2. Install the Mounting Plate
Step 1. Setup position
a. Draw a line down the middle of the studs(See the Wall Construction, page 3)
b. Draw a vertical line on the wall at the center of the 30” wide space.
NOTE: Use the wall template for the rear wall.
Reference Wall Template prior to proceeding.
Step 2. Drilling
WARNING: Electrical shock hazard! To avoid serious injury from electrical shock:
- Locate and disconnect any electrical circuits that could be affected by installation of this product.
- Be careful when drilling holes. Electrical wires may be concealed behind wall and contact with wires can result in electrical shock.
Reference the MOUNTING PLATE INSTALLATION instructions in the Wall Template to perform the wall plate installation
procedure.
IMPORTANT: Once the plate is installed, use a level to ensure that it is perfectly horizontal.
a. Insert toggle bolts through mounting plate at required locations and add the spring loaded toggles.
Be sure you leave space at least the thickness of the wall between the mounting plate and the end of the toggle nut, (in closed
position). If you do not leave this space, the toggle nut will not open on the other side of the wall.
b. Position mounting plate on wall and insert toggle bolt assemblies through the drywall holes.
c. Next, secure mounting plate to the wall by tightening toggle bolt assemblies.
Using Toggle Screws.
Mounting plate
Power Supply Cord Hole
House Duct
Mounting Plate
Dry Wall
Space more than
wall thickness
KOT1G8T_KOT1G9T_설치(영).indd 6 2019-09-18 오후 3:16:02
Loading ...
Loading ...
Loading ...