Loading ...
2
The following is a list of parts you may need for installing your Over-the-Range
microwave oven. You will find the installation hardware contained in a packet with the
unit. Check to make sure you have all these parts. Use this time to become familiar with
each piece.
Tools
The following tools may be needed for
installation of your microwave oven.
Phillips screwdrivers, Electric Drill
Motor, 1/2” & 5/8” Wood Bits & 3/16”
Drill Bit, Saw to cut exhaust opening,
(if needed) or Jig Saw, Tin Snips (if
needed), Pencil, Tape Measure, Paper
Tape & Duct Tape.
Installation Hardware
Mounting Space
66" or more
from the
floor to the
top of the
microwave
oven
30" more than
from cooking
surface
OTR
30"(76,20cm)
2"(5 cm)
max, 12"
Backsplash
Your Over-the-Range microwave oven
requires mounting space on a wall as
shown.
1. A minimum of 30” between wall
hung side cabinets is required for
installation. Make sure the bottom
edge of the top cabinet is at least 66”
from the floor and 30” from the
cooking surface. The cabinet depth
must be no less than 11 inches to
secure top bolts, and no more than 12
inches for sufficient microwave door
and control panel access.
2. For easier access to the hood lamp,
the bottom of the microwave oven
should be at least 2” above the range
backsplash.
3. If you are going to vent your
microwave oven to the outside, see
exhaust duct preparation.
4. Designed to be installed in 30” wide
cabinet opening.
Image Part & Description Q’ty Image Part & Description Q’ty
Lag screws
(1/4” x 1.8”)
2
Top Cabinet
Template
Top Cabinet Template 1
Toggle Bolts and Nuts
3/16 x 2.7”
2
Wall Template
Rear Wall Template 1
Cabinet Mounting Bolts
1/4” x 3-1/8
2
Installation
Manual
Installation Manul 1
Washer (3/4”) 2
Use and
Care
Manual
Use and Care Manual 1
Nylon Grommet
(for metal cabinets)
1 Roller Guide 1
Damper 1
Grease Filters 2
Mounting plate 1 Turn table 1
KOT1G8T_KOT1G9T_설치(영).indd 2 2019-09-18 오후 3:16:01
Loading ...
Loading ...
Loading ...