Loading ...
Loading ...
Loading ...
5
Freezer Door
Tools Needed:
5
⁄
16
" hex-head socket wrench, ³⁄
8
" hex-head
socket wrench, flat 2" putty knife
IMPORTANT:
■ Depending on the width of the opening, you may need to
remove the handle or door to move the freezer into the house.
■ All graphics referenced in the following instructions are
included later in this section after “Final Steps.” The graphic
may be reversed if door swing is reversed.
■ Before you begin, turn the control off, and remove food and
adjustable door or utility bins from door.
Remove and Replace the Handle
To Remove the Handle:
1. Loosen the setscrews located on the side of handle at each
end. See “Handle” graphic.
2. Remove the handle from the grommets.
To Replace the Handle:
1. Place the handle onto the grommets, making sure the
grommets are fitted into the handle holes.
2. Tighten the upper and lower setscrews with the hex key
provided. See “Handle” graphic. Do not overtighten the
setscrews.
Remove Door and Hinges
Hex-head hinge screws
1. Unplug freezer or disconnect power.
2. Keep the freezer door closed until you are ready to lift it free
from the cabinet.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
3. Remove the parts for the top hinge as shown in “Top Hinge”
graphic.
4. Lift the freezer door free from the lower hinge and cabinet and
set aside.
5. Remove the four hex-head hinge screws and bottom hinge
assembly. See “Bottom Hinge” graphic.
Replace Door and Hinges
NOTE: Graphic may be reversed if door swing is reversed.
1. Replace the parts for the bottom hinge as shown and tighten
screws. See “Bottom Hinge” graphic. Replace the freezer
door.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
2. Assemble the parts of the top hinge as shown in the “Top
Hinge” graphic. Do not tighten the screws completely.
Final Steps
1. Check all holes to make sure that hole plugs and screws are
in place. Reinstall top hinge cover. See “Top Hinge” graphic.
2. Using the provided decals, cover the remaining holes located
on the opposite side from the bottom hinge.
3. Plug into a grounded 3 prong outlet.
4. Reset the control. See “Using the Control.”
5. Return all removable door parts to door and food to freezer.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Loading ...
Loading ...
Loading ...