Loading ...
Loading ...
Loading ...
EN 19
Switching on and power setting
1. Press the key button.
A single audio signal sounds.
2. Place a pan in the middle of a cooking zone.
The APd registers a pan and a flashing ‘-’ appears in the display.
If you don’t do anything else, the cooking zone will switch off
automatically after 10 seconds.
3. Slide with your finger over the slide control (clockwise) or tap with
your finger on the slide control to set the desired setting. The
cooking zone starts automatically at the setting that has been set.
4. Set a higher or lower power by sliding with your finger over the slide
control or by tapping the slide control. The cooking zones have 12
settings. There is also a ‘boost’ setting for the induction zones.
Please note!
If the APd function is switched off, activate a cooking zone using the
on/off button.
Automatic pan detection (APd)
Once the hob is switched on, if a pan is placed on an inactive cooking
zone, the corresponding control will light up and can be operated
immediately (without operating the on/off button). If the cooking
zone is not switched on within 10 seconds it will switch itself off again.
The cooking zone can be reactivated by removing the pan and
replacing it on the cooking zone or by using the on/off button.
This function is active as standard, but can also be disabled.
Disable the function by switching off the hob. Then from the Eco
stand-by mode operating the ‘Pause’ button (09) for 5 seconds. The
display will read ‘APd OFF’. By repeating this action, the function will
be reactivated and ‘APd On’ will appear in the display.
Please note!
If the hob doesn’t detect a pan, with or without iron content, after a
power level has been set, the display will continue to flash and the
cooking area will remain cold. If no pan with or without iron content is
placed on the zone within one minute, the cooking zone will switch off
automatically.
F00002557 - LED Screen ATAG TC (700002940000)
24-08-09 IH
INDUCTION OPERATION
Loading ...
Loading ...
Loading ...