Loading ...
Loading ...
Loading ...
2A.Models with Factory Connected Power
Supply Cord
NOTE: Some models may be equipped with a factory
connectedthree (3) conductorpowersupplycord.
Mobile home installations,new branch circuit installations
(1996NEC) or areas where local codes do not permit
grounding through neutral require a four (4) conductor power
supply cord kit rated at 125/250 volts minimum and marked
for use with ranges. See Range Connection Opening Size
Chart for cord kit ampere rating information. Terminals on
end of wires must be either closed loop or open-end spade
lugs with upturned ends.
2B.Models Requiring Power Supply Cord Kit
RISK OF FIRE OR ELECTRICAL SHOCK MAY OCCUR IF
AN INCORRECT SIZE RANGE CORD KIT IS USED, THE
INSTALLATION INSTRUCTIONS ARE NOT FOLLOWED
OR STRAIN RELIEF BRACKET IS DISCARDED.
This appliance may be connected by means of a power
supply cord. Only a power supply cord kit rated at 125/250
volts minimum, and marked for use with ranges shall be
used. See chart on page 3 for cord kit ampere rating
information. Cord must have either three (3) or four (4)
conductors. Terminals on end ofwires must be either closed
loop or open-end spade lugswith upturned ends. Cord must
have strain relief clamp.
See section 4A for 3-wire or section 4B for 4-wire connection.
3. Electrical Connection to Range
The rear accesscover mustberemoved.To remove,loosen
center screw (one screw) and remove access cover. The
terminal blockwillthen be accessible.
Cover
Rear
of Range
Range Connection Opening Size Chart
Supply Cord Kit ampere rating information. Seeserial plate on range for
kilowatt rating data.
See Serial Plate on Range for
KW Rating
120/240 Volts 120/208 Volts
8.8-16.5 KW 7.9-12.5 KW
16.6-22.5 KW 12,6-18.5 KW
Cord Kit Diameter (inches) of Range
Ampere connection Opening
Rating Permanent
Cord Kit Wirinq
40/50 tunp 1-3/8 in. 1-1/8 in.
50 Amp 1-3/8 in. 1-3/8 in,
1-1/8" Dia. 7/8" Dia. _"
Knockout Hole
(_) (See Chart) 4"
Hole _
(See Chart)
Pocket
for Cable
Mounting Plate
NOTE: Range isshipped from factory with 1-3/8" dia. hole as
shown. To use either 7/8" dia. hole or 1-1/8" dia. knockouts:
Ifa different diameter hole is required, please follow the
steps below:
1. Usinga 1/4"socketdriver,remove eight(8) screwsfrom
Rear Wall Shield to release from the unit (as shown).
Save the screwsfor step#7 below.
2. Again usingthe 1/4" socketdriver,remove one (1) blunt
pointscrewused to securethe Cable MountingPlate to
the Rear Wall Shield. Save the screws for step #6.
3. Remove the Cable Mounting Plate from the Rear Wall
Shield by sliding the plate out of the pockets.
4. If a 1-1/8"dia. holeisrequired,"punch-out"the knockout.
5. Rotate the plate 180 degrees so that the desired hole is
placed ontop ofthe opening located on thebottom flange
of the Rear Wal! Shield.
6. Slide the Cable Mounting Plate into the RearWall Shield.
Re-secure usingthe blunt point screw removed from step
#2 above.
7. Reassemble the Rear Wall Shield to the unit using eight
(8) screws removed from step #1 above.
4
Loading ...
Loading ...