Loading ...
Loading ...
Loading ...
5
LOCATING AND ASSEMBLING THE GRILL:
When determining a suitable location for your grill, take into account concerns such as exposure to wind,
rain, sprinklers, proximity to traffic paths and keeping any gas supply line runs as short as possible.
Locate the grill only in a well-ventilated area. Never locate the grill in a building, garage, breezeway,
shed or other such enclosed areas without an approved ventilation system. Never locate the grill over,
under or next to unprotected combustible construction. During heavy use, the grill will produce a lot of
smoke.
CLEARANCES:
TO NON-COMBUSTIBLE CONTRUCTIONS:
A minimum of 3-5/8” clearance from the back of the grill to non-combustible construction is required to
allow the lid to be opened fully.
TO COMBUSTIBLE CONTRUCTIONS:
This appliance should NOT be located over, under or next to unprotected combustible construction. If
your enclosure is combustible, then an INSULATED JACKET manufactured by ALFRESCO™ Gourmet
Grills, is required. For the insulated jacket information, such as cut out sizes and part numbers, please
refer to the last page of this manual.
ASSEMBLY:
BUILT-IN MODELS:
Before locating your ALFRESCO™ Gourmet Grill into your Non-Combustible enclosure, complete the
following steps:
1. Remove all packaging materials.
2. Ensure that the burners are positioned correctly on their orifices, and are fully seated onto
their supports.
3. Position the briquette trays onto their locating pins and place briquettes evenly across tray.
4. Ensure that new batteries are fitted and the igniter cap is properly installed. See Battery
installations instructions on next page.
5. Make the connection to the gas regulator according to the instructions on pages 6 & 7 for
your gas type.
6. To comply with safety and service requirements, main gas shut off valve must be accessi-
ble from front of grill without using any tools.
Your Alfresco™ Gourmet Grill has provision for mounting onto a mobile cart if you choose to do so.
Contact your Alfresco™ dealer for the appropriate cart for your grill.
FREE STANDING MODELS:
Complete the following steps:
1. Remove all packaging materials.
2. Ensure that the burners are positioned correctly on their orifices, and are fully seated onto
their supports.
3. Position the briquette trays onto their location pins and place briquettes evenly across tray.
4. Ensure that new batteries are fitted and the igniter cap is properly installed. See Battery
installations instructions on next page.
5. Make the connection to the gas regulator according to the instructions on pages 6 & 7 for
your gas type.
6. Allow a minimum of 3” clearance around all sides of grill cart for proper air movement.
7. Lock the rear casters to prevent unwanted grill movement.
Loading ...
Loading ...
Loading ...