Loading ...
Loading ...
Loading ...
118
MAINTENANCE
Replacing the Lamp
When the time of use of the lamp exceeds 1,400 hours (1,800 hours or longer for SX7/
X700, 2,300 hours or longer for SX60), the following message (two types) is displayed for
10 seconds each time the projector is turned on.
z When the time of use is 1,400 to 1,500 hours:
1,800 to 2,000 hours for SX7/X700
2,400 to 2,500 hours for SX60
z When the time of use is 1,500 hours or longer:
2,000 hours or longer for SX7/X700
2,500 hours or longer for SX60
Replacing Lamp
This projector uses the following lamp.
Lamp type No. SX7/X700: RS-LP04
SX6 : RS-LP02
SX60 : RS-LP03
z This message will not be displayed again if you select [No] in response to the message "Do
you want to display this message again?".
z You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu
(P114).
Caution
z When replacing the lamp, turn off the projector, wait until the cooling fan stops,
remove the power plug from the AC outlet, and let the projector stand for at least 1
hour. Otherwise, you may get burned because the main unit is very hot immediately
after the projector is turned off.
z Do not touch the inner glass surface when you replace the lamp. Otherwise, the pro-
jector's performance may degrade.
z Make sure to handle the lamp carefully and correctly since it may explode if it is
scratched or shocked.
z Do not remove screws unless specified.
z Be sure to use the specified lamp.
z A lamp can be ordered from your dealer or Canon home page.
* [<], [>], the [OK] button, and the [POWER]
button are available during this message is
displayed.
* The [POWER] button is available during this
message is displayed.
Loading ...
Loading ...
Loading ...