Loading ...
Loading ...
Loading ...
Changing LaneSense Status
The LaneSense system has settings to adjust the intensity of
the torque warning (Low/Medium/High) and the warn-
ing zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system screen. Refer to
“Uconnect Settings” in “Multimedia” for further informa-
tion.
NOTE:
• The system will not apply torque to the steering wheel
whenever a safety system engages (anti-lock brakes,
traction control system, electronic stability control, for-
ward collision warning, etc.).
• Use of the turn signals and Hazard Warning flashers also
suppresses the warnings.
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see an
on-screen image of the rear surroundings of your vehicle
whenever the gear selector is put into REVERSE. The
image will be displayed in the touchscreen display along
with a caution note to “check entire surroundings” across
the top of the screen. After five seconds this note will
disappear. The ParkView camera is located on the rear of
the vehicle above the rear license plate.
NOTE: The ParkView Rear Back Up Camera has program-
mable modes of operation that may be selected through the
Uconnect System. Refer to “Uconnect Settings” in “Multi-
media” for further information.
When the vehicle is shifted out of REVERSE (with camera
delay turned off), the rear camera mode is exited and the
previous screen appears again. When the vehicle is shifted
out of REVERSE (with camera delay turned on), the camera
image will continue to be displayed for up to 10 seconds
after shifting out of REVERSE unless the vehicle speed
exceeds 8 mph (13 km/h), the vehicle is shifted into PARK
or the vehicles ignition is switched to the OFF position.
NOTE: With Camera Delay turned on, the camera image
can be disabled via the Image Defeat (X) button on the
touch screen when the vehicle is shifted out of REVERSE.
When enabled, active guide lines are overlaid on the image
to illustrate the width of the vehicle and its projected
backup path based on the steering wheel position. A
dashed center line overlay indicates the center of the
vehicle to assist with parking or aligning to a hitch/
receiver.
Different colored zones indicate the distance to the rear of
the vehicle.
300 STARTING AND OPERATING
Loading ...
Loading ...
Loading ...