Loading ...
Loading ...
Loading ...
Keyless Enter-N-Go Functions — Using The ENGINE
START/STOP Button
1. The transmission must be in NEUTRAL.
2. Press and hold the clutch pedal while pushing the
ENGINE START/STOP button once.
3. The system takes over and attempts to start the vehicle.
If the vehicle fails to start, the starter will disengage
automatically after 10 seconds.
4. If you wish to stop the cranking of the engine prior to
the engine starting, push the button again.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal.
Keyless Enter-N-Go Functions — With Driver’s Foot OFF
The Brake Pedal/Clutch Pedal (In PARK Or NEUTRAL
Position)
The Keyless Enter-N-Go feature operates similar to an
ignition switch. It has three positions, OFF, RUN, and
START. To change the ignition switch positions without
starting the vehicle and use the accessories follow these
steps starting with the ignition switch in the OFF position:
1. Push the ENGINE START/STOP button once to change
the ignition switch to the RUN position,
2. Push the ENGINE START/STOP button a second time
to change the ignition switch to the OFF position,
Cold Weather Operation (Below –22°F Or −30°C)
To ensure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your authorized dealer) is recommended.
Extended Park Starting
NOTE: Extended Park condition occurs when the vehicle
has not been started or driven for at least 30 days.
1. Install a battery charger or jumper cables to the battery
to ensure a full battery charge during the crank cycle.
2. Cycle the ignition in the START position and release it
when the engine starts.
3. If the engine fails to start within ten seconds, cycle the
ignition to the OFF position, wait five seconds to allow
the starter to cool, then repeat the Extended Park
Starting procedure.
232 STARTING AND OPERATING
Loading ...
Loading ...
Loading ...