Loading ...
Loading ...
Loading ...
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLinkt for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLinkt button you wish to program.
Place the hand-held transmitter 1–3 inches (3–8 cm) away
from the HomeLinkt button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLinkt button and the hand-held transmitter button
until the HomeLinkt indicator changes from a slow to a
rapidly blinking light, then release both the HomeLinkt
and hand-held transmitter buttons.
Watch for the HomeLinkt indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open & close while you train.
NOTE:
•
Some gate operators and garage door openers may
require you to replace Step #3 with procedures noted
in the “Gate Operator/Canadian Programming” sec-
tion.
•
After training a HomeLinkt channel, if the garage
door does not operate with HomeLinkt and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so,
proceed to the heading “Programming A Rolling Code
System.”
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
3
Loading ...
Loading ...
Loading ...