Loading ...
Loading ...
Loading ...
31
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical oor mounting
Alternate positions
for stability location
bracket
Stability chain
Fig. 7.5
Fig. 7.6
Fig. 7.7
Fig. 7.8
Fitting the Stability Bracket or Chain
Unless otherwise stated, a cooker using a exible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 7.5, Fig. 7.6,
Fig. 7.7 and Fig. 7.8.
If you are using a stability chain (Fig. 7.5) then the chain
should be kept as short as is practicable and xed rmly to
the rear of the cooker.
If you are using a stability bracket; rst attach the bracket
location device to the rear of the cooker (Fig. 7.6). Then
adjust the bracket to engage through the slot of the device
(Fig. 7.7 and Fig. 7.8).
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 7.3), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sucient slack to allow the cooker to
move.
With a stability chain tted, release it as you ease the cooker out.
Do not forget to ret it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
Loading ...
Loading ...
Loading ...