Loading ...
Loading ...
Loading ...
4. Press together hinge trim, see arrow, to re‐
lease the clips.
Grasp the trim, pull the hinge trim down‐
ward and remove it.
5. Carefully loosen the trim from the trunk lid,
starting at the edge and working toward
the area around the recessed grips. Make
sure that the trim does not become stuck.
6. Carefully swing out the trim.
Replacing the reversing lamp and inner
brake lamp
1.
Loosen the bottom holder, arrow 1.
2. Loosen the top holder, arrow 2. To do so,
press in the middle latch and then press
out both outside latches.
Remove the lamp holder, arrow 3.
3. Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.
4. Insert the new bulb.
Installing the bulb holder
1. Insert the two contacts, arrow 1, into the
connections, arrow 2.
2. Press on the bulb holder, arrow 3. Make
sure that the two exterior holders latch into
place.
3. Swing the trim back onto the trunk lid and
secure.
4. Place the hinge trim over the hinge and
push it up until the retaining pin engages.
Close the clips.
5. Install the wire cable on the handle and en‐
gage the handle on the holder.
6. Install the holder for the warning triangle.
7. Apply the warning triangle.
Rear lamp, license plate lamp and
central brake lamp
Follow general instructions, refer to page 190.
These lights are made using LED technology.
Contact your service center in the event of a
malfunction.
Changing wheels
Hints
When sealants are used, an immediate wheel
change when there is a loss of tire inflation
pressure in the event of a flat tire is unneces‐
sary.
Which is why no spare tire is available.
Seite 195
Replacing components Mobility
195
Online Edition for Part no. 01 40 2 960 786 - II/15
Loading ...
Loading ...
Loading ...