Loading ...
Loading ...
Loading ...
that the foam rubber sealing ring is on the
centering pin.
6. Release the catch at the top on the con‐
nector of the connecting line and remove
the connector from the bulb holder.
Replacing the bulbs
1.
Loosen the three fasteners, arrows 1, on
the bulb holder and remove the bulb holder
from the tail lamp, arrow 2.
2. Press the defective bulb gently into the
socket, turn counterclockwise and remove.
3. Proceed in the reverse order to insert the
new bulb and attach the bulb holder. Make
sure that the bulb holder engages in all fas‐
teners.
Installing the tail lamp
1.
Connect the connecting line to the tail
lamp and secure the bulb holder in the clip.
2. Make sure that the foam rubber sealing
ring is on the centering pin, arrow 2, and is
not damaged.
3. Position and firmly press the outer part of
the tail lamp onto the rubber mount, ar‐
row 1 and the inner part onto the centering
component, arrow 2. Make sure that the
tail lamp engages in the rubber mount.
4. Screw the tail lamp on with the two nuts.
5. Insert and secure the cover. Make sure that
the tubular seal is not pinched.
Lights in the trunk lid
General information
Follow general instructions, refer to page 190.
Reversing lights: 16-watt bulb, PW16W.
Inner brake lights: 21-watt bulb, H21W
Accessing the lights
1.
If needed, remove warning triangle, refer to
page 200, and bracket with the screw‐
driver from the onboard vehicle tool kit, re‐
fer to page 190.
2. Remove the emergency release and the
wire cable from the handle.
3. Use the screwdriver from the onboard ve‐
hicle tool kit to loosen and completely re‐
move the screws on the trim.
Seite 194
Mobility Replacing components
194
Online Edition for Part no. 01 40 2 960 786 - II/15
Loading ...
Loading ...
Loading ...