Loading ...
Loading ...
Loading ...
20
T
o transport your steam generator using the handle of the iron :
- place the iron in position onthehousing plateonthesteamgenerator and foldthering over the
iron until it locks into position (you will hear a “click”) - fig.2.
-
Hold the iron by the handle to transport your steam generator - fig.1.
What water may be used ?
• Your iron has been designed to operate using untreated tap water.
• Heat concentrates the elements contained in water during evaporation. The types of water
listed below contain organic waste or mineral elements thatcan cause spitting, brown staining
or premature wear of the appliance: water from clothes dryers, scented or softened water,
water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or
rain water should not be used in your iron. Also do not use boiled, filtered or bottled water.
I
f your waterisvery hard (check
with your local water authority)
it is possible to mix untreated
t
ap waterwith store-bought
distilled ordemineralisedwater
in the following proportions:
50% untreated tapwater, 50%
distilled ordemineralisedwater.
Preparation
Filling the water tank
• Place the steam generator on a stable, horizontal and heat-resistant surface.
• Ensure that your steam generator is unplugged and that the soleplate and the iron rest have
cooled down.
• Open the water tank filler cover - fig.4.
• Pour in untreated tap water up to the max mark - fig.5.
• Close the water tank filler cover.
• Your iron is equipped with an extension cord system to prevent the cord from dragging over
the laundry and creasing it again when ironing.
• Take the steam cord out of its housing and unwind it completely.
• Remove the tie to release the cord outlet.
• Press the Eject button - fig.6 and the Easycord system extends automatically.
• When the cord outlet tips, the Easycord system extends automatically without you having to
press the Eject button.
Using the Easycord system
Operating the control panel
• Green light flashes: the boiler heats up. - fig.7.
• Green light on: the steam is ready - fig.7.
• Red light “water tank” on: the water tank is empty - fig.10.
• The orange “anti-calc” indicator flashes - fig.12: you need to rinse the scale collector.
Switch on the steam generator
• Completely unwind the power cord and the steam cord from its storage space.
• Lower the retaining hoop (depending on model) to unlock the safety catch - fig.3.
• Plug your steam generator into a mains socket with an earth pin”.
• Press on the on / off switch. The green light (located on the control panel) flashes and the
boiler heats up - fig.7.
When the green “steam ready” light stops flashing (after 2 minutes approximately), the
appliance is ready.
The first time the appliance is
used, there may be some
fumes and smell but this is
not harmful. They will not
affect use and will disappear
rapidly.
Steam ironing
• Placetheiron'stemperaturecontrolslideaccordingtothetypeoffabricto beironed(seetable below).
• The thermostat light comes on. Be careful ! The steam generator is ready when the thermostat
light goes out and when the green “steam ready” light stays on.
• Adjust the steam output control dial (located on the control panel).
• While ironing, the light on top of the iron and the steam ready light turn on and off, as the
temperature adjusts without interrupting ironing.
• To obtain steam, press on the steam control button under the iron handle and keep it pressed -
fig.8. The steam will stop when you release the button.
• When starting, and regularly while it is being used, your steam generator's electric pump injects
waterinto the boiler. It makes a noise but this is quite normal. You may also hear aclicking noise
which is the steam valve opening. Again this is normal.
• Always spray starch onto the reverse side of the fabric to be ironed.
Use
Do not place the iron on a
metal support.When
taking a break from
ironing, always place
the iron on the iron rest
plate of the unit. It is
equipped with non-slip
pads and has been
designed to withstand
high temperatures.
Always use the Easycord
system for enhanced
comfort of use.
Ironing Boards:
D
ue to the powerful steam
output, a mesh type ironing
board must be used to allow
a
ny excess steam to escape
and to avoid steam venting.
1800115593 TEFAL ExpressAnticalc:1800115593 5/02/09 11:36 Page 20
Loading ...
Loading ...
Loading ...