Loading ...
Loading ...
Loading ...
;@A.99.A6<;;@A?B0A6<;@
%.;42
If you have questions, call 1.800.GE.CARES <?visit our Website at: GEAppliances.com
"%,"(!
%2.1A52@26;@A?B0A6<;@0<:=92A29F.;10.?23B99F
;@A.99.A6<;<3A56@?.;42:B@A0<;3<?:D6A59<0.9
0<12@<?6;A52./@2;02<39<0.90<12@D6A5A52
!.A6<;.9B29.@<12!&-!#9.A2@A
216A6<;;.;.1.6;@A.99.A6<;:B@A0<;3<?:D6A5
A520B??2;A!.AB?.9.@;@A.99.A6<;<12!
<?A520B??2;A#?<=.;2;@A.99.A6<;<12
!.;1D6A59<0.90<12@D52?2
.==960./92'56@?.;425.@/22;12@64;02?A63621
/F&;A2?;.A6<;.9.00<?16;4A<!&-9.A2@A
216A6<;.;1.;.16.;.@@@<06.A6<;.00<?16;4
A<!9.A2@A216A6<;
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow.
You will find these precautions in the ;>=@B/<B(/43BG
<4=@;/B7=< section in the front of this manual. Read
them carefully.
•
#"%'!'ISave these instructions
for local electrical inspector’s use.
•
#"%'!'IObserve all governing codes
and ordinances.
• !<A2A<;@A.992?I Be sure to leave these
instructions with the Consumer.
• !<A2A<<;@B:2?I Keep these instructions
for future reference.
• !<A2I This appliance must be properly grounded.
• &2?C602?I The electrical diagram is in an envelope
attached to the back of the range.
• &869992C29I Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
"%,"(%&',
<;<A@A<?2<?B@20<:/B@A6/92:.A2?6.9@4.@<96;2<?
<A52?39.::./92C.=<?@.;196>B61@6;A52C606;6AF<3A56@
<?.;F<A52?.==96.;02
3F<B@:2994.@
Open windows.
Don’t touch electrical switches.
Extinguish any open flame.
Immediately call your gas supplier.
'""&,"(*!
'%&,"( ,!
• Gas line shut-off valve.
• Pipe-joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP gases.
• Flexible metal appliance connector (1/2″ I.D.)
A 5-foot length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(3/4″ or 1/2″ NPT x 1/2″ I.D.)
• Flare union adapter for connection to pressure regulator
on range (1/2″ NPT x 1/2″ I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2″ O.D. sleeve anchor (for concrete floors
only).
*Teflon: Registered trademark of DuPont
Flat-blade screwdriver
Pipe wrenches (2)
(one for backup)
Phillips screwdriver
Open-end or
adjustable wrench
Pencil and ruler
Level
;A52<::<;D2.9A5<3 .@@.05B@2AA@
H This product must be installed by a licensed plumber
or gas fitter.
H When using ball-type gas shut-off valves, they shall
be the T-handle type.
H A flexible gas connector, when used, must not exceed
3 feet.
Drill, awl or nail
#%'!(
Anti-Tip bracket kit
Loading ...
Loading ...
Loading ...