Loading ...
Loading ...
Loading ...
6
INSTALLATION
Refrigerator
⅜”
(10 mm)
1" (25mm)
1"
(25mm)
⅜”
(10 mm)
Installation
Installation clearances:
• Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides - ⅜”
Top and Back - 1”
• Allow for trim kit if it is to be installed
with the unit.
NOTE
If your refrigerator is placed with the door
hinge side against a wall, you may have to
allow additional space so the door can be
opened wider.
Components:
1. Follow this Use & Care Guide for unit
installation, dimensions, and guidelines.
2. Be sure to level the unit before installation
(see “Leveling” in Installation section).
3. Find anti-tip bracket, 4 screws, and
4 anchor screws included inside the
components bag.
4. Identify a stud in the wall, behind where
the unit will be placed, and make a mark
on the wall (see Figure 1). If no stud is
present behind where the hole is marked,
go to step 6.
1 x
Bracket
4 x
Screws
4 x
Drywall
Anchors
5. Align one of the center holes of the
bracket with the stud. If the bracket
extends past the edge of the unit, use a
different stud or proceed with instruction 6
(see Figure 2).
Stud
Mark location
for bracket
on the wall
Figure 1
Anti-Tip Installation
WARNING
The anti-tip bracket must be installed to
prevent the unit from tipping over. Failure to
do so may result in injury or property damage.
Best Good Bad
Figure 2
Bracket alignment
Loading ...
Loading ...
Loading ...