Loading ...
Loading ...
Loading ...
16
Foldaway door bar (mullion bar)
- When closing the left refrigerator door, the mullion bar
folds behind the right refrigerator door, foaming a seal
between the refrigerator doors.
- When opening the left refrigerator door, the mullion bar
folds back to the left door automatically.
(mullion bar folds back O) (mullion bar folds away X)
- The mullion bar become damaged if you attempt to close
the left refrigerator door with mullion bar fold away
When closing the left refrigerator door, make sure the
mullion bar is folded back.
Water filter
1. Disconnect the water supply to the
appliance.
2. Remove the locking cap for
installing the filter.
(The ice and water dispenser can
also be used without a water filter,
in which case the locking cap must
be used. )
3. Carefully turn the filter clockwise.
4. Change the filter at least every
6months.
A New filter can be obtained from aftersales service.
Caution
●Wipe up with cloth if droplets fall when
exchanging a filter. Draw water from the water
dispenser for 5 minutes before use. This will
remove air from the water system.
Information concerning the water filter
- After use, the water system is subject to low pressure.
Proceed with caution when removing the filter.
- Flush the water system if the appliance has not been in
use for a lengthy period, or if the ice/water has an
unpleasant taste or smell. To do this, dispense water
through the water dispenser for several minutes.
If the unpleasant taste or smell remains, replace the filter.
- Protect from frost, remove the filter cartridge if you expect
the temperature to drop below freezing.
- If pressure surges could occur in the water pipe. Do not
install the water filter without a suitable surge eliminator.
Contact an installation expert if you are not sure whether
pressure surges could occur in the water pipe.
- After installing a new filter:
Discard any ice produced in the first 24 hours after
switching on.
- If no ice has been removed for a lengthy period: Empty the
ice box and discard any ice produced over the next
24hours.
How to install Water Line
1. The water pressure should be 2.0 ~ 8.8kgf/㎠
(1.96~8.62 Bar)or more to run the automatic icemaker.
Checkup your tap water pressure ; if a cup of 180cc is
full within 10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not
close to any hot surfaces.
3. The water filter only filters water ; it does not eliminate
any bacteria or microbes.
4. If the water pressure is not so high to run the icemaker,
call the local plumber to get an additional water pressure
pump.
5. If the water pressure exceeds 8.8kgf/㎠(8.62Bar) a
pressure reducing valve must be installed.
6. The filter life depends on the amount of use. We
recommend you replace the filter at least once every
6 months.
7. After installation of refrigerator and water line system,
select [WATER] on your control panel and press it for
2~3 minutes to supply water into the water tank and
dispense water.
8. Use sealing tape to every connection of pipes/tubes to
ensure there is no water leak.
9. The water tube should be connected to the cold water
line.
Loading ...
Loading ...