Loading ...
Loading ...
Loading ...
15
Aligning the refrigerator doors
Caution
※ Risk of electric shock! Before removing top hinge cover
·Shut off the water supply to the appliance.
·Unplug the appliance or switch off the fuse.
If the refrigerator doors are not properly aligned
Unscrew the top hinge cover and raise the panel
Do not disconnect any harness wire or water tube!
Loosen the fastener counterclockwise, move the hinge
sideway to adjust the refrigerator door.
Do not remove the fastener!
Tighten the fastener and replace the top hinge cover.
Adjusting the freezer drawer
If the freezer drawer is not even.
1. Loosen the two side fasteners.
Do not remove the fasteners!
2. Use the top fastener to adjust the freezer drawer.
3. If level of freezer drawer is proper, tighten the two side
fasteners.
Front Cover
After installation and/or door leveling, fasten front cover with
screws. (Remove the screws on the front bottom panel first.
Click and screw the cover)
Caution
●The front of refrigerator needs to be just a little
higher than the back for easy door closing, but if
the wheel is raised too much for door balance,
i.e. the front of refrigerator is much higher than
the back, it can be difficult to open the door.
Installing the handles
- After installation and/or door leveling, Install the handles.
- All the handles are identical
Insert refrigerator door handles into guide, the direction
of set screw being to the center of the appliance.
Fasten the set screw with the L- wrench(supplied).
Insert freezer door handles into guide,
the direction of set screw being to downward.
Fasten the set screw with the L- wrench(supplied).
1
2
3
1
2
Loading ...
Loading ...
Loading ...