Loading ...
Loading ...
Loading ...
Attaching the Base Plate to the Motorcycle Mount
NOTICE
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
À
through the
washers
Á
, cradle, spacers
Â
, and base plate
Ã
.
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
À
and the ball of the
base plate
Á
with each end of the double-socket arm
Â
.
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Installing Your Device in the Motorcycle Mount
1
Fit the left side of your device into the cradle.
2
Push the right side of the device forward until it snaps into
place.
3
If the latch
À
on the mount stays up after you insert the
device, press it down.
Removing Your Device from the Motorcycle
Mount
1
Press the release button on the bottom of the mount.
2
Lift out the device.
Mounting Your Device in an Automobile
NOTICE
Before mounting the device, check the local laws pertaining to
windshield mounting.
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
NOTE: The automobile mount is not included with all device
models. Go to garmin.com to purchase optional accessories.
1
Plug the automotive power cable
À
into the port
Á
on the
mount.
2
Remove the clear plastic from the suction cup
Â
.
3
Clean and dry your windshield and the suction cup with a lint-
free cloth.
4
Press the suction cup to the windshield, and flip the lever
Ã
back toward the windshield.
5
Snap the cradle
Ä
onto the suction cup arm.
6
Fit one side of your device into the cradle.
7
Press the device into the cradle until it snaps into place.
8
Plug the other end of the automotive power cable into a
power outlet.
Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
• Update the maps and software on your device (Product
Updates, page 22).
• Mount the device and connect it to power.
• Pair your Bluetooth
®
phone and headset (Pairing Your Phone
and Headset, page 13) (optional).
• Acquire GPS signals (Acquiring GPS Signals, page 3).
• Adjust the screen brightness (Adjusting the Screen
Brightness, page 3).
• Navigate to your destination (Starting a Route, page 5).
2 Getting Started
Loading ...
Loading ...
Loading ...