Loading ...
Loading ...
Loading ...
23
3. Insert a 1/8" (3 mm) at-blade screwdriver into the
adjustment locations shown in the following illustration and
engage the slotted screw. Turn the screw until the ame is
the proper size. Turning the screw clockwise will increase the
ame size and turning the screw counterclockwise will
decrease the ame size.
4. Replace the control knob.
5. Test the ame by turning the control from the low position to
the high position, checking the ame at each setting.
Check Operation of Oven Bake Burner
Refer to the User Guide for proper operation of the oven controls.
Adjust Oven Bake Burner Flame (If Needed)
1. Remove the premium storage drawer, warming drawer or
baking drawer (see the “Remove/Replace Drawer” section).
2. Locate gas pressure regulator at rear of the drawer
compartment.
NOTE: On models with a warming drawer or baking drawer,
an access cover must be removed to access the gas
pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
3. Check the oven bake burner for proper ame.
a. Remove the oven racks.
b. To remove the oven bottom: Remove 2 screws at the
rear of the oven bottom. Lift the rear of the oven bottom
up and back until the front of the panel is away from the
front frame. Remove from oven and place on a covered
surface.
c. Press BAKE.
d. Press the Start pad.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
A
A. Gas pressure regulator
A
B
A. Screws
B. Oven bottom
The oven bake burner should light within 8 seconds. Under
certain conditions, it may take the burner up to 50 to 60
seconds to light.
Electronic igniters are used to light the bake and broil
burners.
This ame should have a 1/2" (1.3 cm) long inner cone of
bluish-green with an outer mantle of dark blue and should be
clean and soft in character. No yellow tips, blowing, or lifting
of ame should occur.
If the oven bake ame needs to be adjusted, locate the air
shutter near the center rear of the drawer cavity behind the
access panel. Loosen the locking screw and rotate the air
shutter until the proper ame appears. Tighten locking screw.
4. Push the Off pad when nished.
5. Reinstall the oven bottom and the storage drawer
(see the “Remove/Replace Drawer” section).
Adjust Oven Broil Burner Flame (If Needed)
Press BROIL, and then press the start pad. Look through the
oven window to check broil burner for proper ame. This ame
should have a 1/2" (1.3 cm) long inner cone of bluish-green with
an outer mantle of dark blue and should be clean and soft in
character. No yellow tips, blowing, or lifting of ame should be
present.
If Flame Needs to be Adjusted:
1. Press the Off pad. Let the oven cool.
2. Loosen the lock screw on the air shutter located at the rear
of the broil burner.
3. Adjust the air shutter as needed.
4. Tighten lock screw.
5. Close the oven door. Press BROIL, and then press the Start
pad. Look through the oven window to check broil burner for
proper ame. If ame needs to be adjusted, repeat steps 1
to 5.
A
B
A. Locking screw
B. Air shutter
A
B
A. Lock screw
B. Air shutter
Loading ...
Loading ...
Loading ...