Loading ...
Loading ...
Loading ...
17
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with
a 5/8" (1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
“êLP” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Remove the burner base.
A
B
C
X-Large Burner
A.Burner cap
B.Burner base
C.Choke (for use with x-large
burner, Propane gas only)
A
B
C
D
Side view before
Side view after
E
NG
LP
NG
LP
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
D
A
B
C
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orice spud in the nut driver while
changing it. Press nut driver down onto the gas orice spud
and remove by turning it counterclockwise and lifting out.
Set gas orice spud aside.
4. Remove the orice spuds shipped in the literature package
in the oven. Gas orice spuds are stamped with a number
and have a groove in the hex area. Replace the Natural gas
orice spud with the correct Propane gas orice spud.
Refer to the following chart for correct Propane gas orice
spud ratings and to spud holder card for proper placement.
Fully insert choke into bottom of x-large burner base. Choke
should snap into place.
NOTE: Use only for spreader bases marked “XL.”
Propane Gas Orice Spud Chart for Surface Burners
Placement Burner
Rating/Type
Size (mm) ID Number
LF 14,200 BTU 1.08 108AM
LF (ST) 15,000 BTU 1.08 108AM
LR 5,000 BTU 0.64 064AM
RF 14,200 BTU 1.08 108AM
RR 8,000 BTU 0.84 084AM
CTR 8,000 BTU 0.84 084AM
NOTE: Refer to the model/serial/rating plate located on the oven
frame behind the top left-hand side of the oven door for proper
sizing of spuds for each burner location.
5. Place Natural gas orice spuds in the orice spud bag.
IMPORTANT: Keep the Natural gas orice spuds in case
of reinstallation with Natural gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 to 7 for the remaining burners.
A
B
C
D
A. Igniter electrode
B. Orice spud
C. Orice spud holder
D. Screws
A
A. Propane groove
Loading ...
Loading ...
Loading ...