Loading ...
Loading ...
Loading ...
Seats and head restraints
Electric driver's seat adjustment*
Read the additional information carefully
›››
page 19
WARNING
●
If the electric
front seats are used negli-
gently or without paying due attention, it can
cause serious injury.
●
The front seats can also be electrically ad-
justed when the ignition is switched off. Nev-
er leave a child or any other person who may
need help in the vehicle.
●
In the event of an emergency, electrical ad-
justment can be stopped by pressing any
control.
CAUTION
To avoid damaging the electrical components
of the front
seats, please refrain from kneel-
ing on the seat or applying sharp pressure at
a single point to the seat cushion and back-
rest.
Note
●
It ma
y not be possible to electrically adjust
the seat if the vehicle battery is very low.
●
If the engine is started while the seats are
being electrically adjusted, the adjustment
will stop.
Adjusting the front head restraints
Read the additional information carefully
›››
page 19
Adjust the head restraint ›››
page 19 so
that as far as possible the top of the head re-
straint is level with the top of your head.
When this is not possible, try to get as close
as possible to this position.
Adjustment of the rear head restraints
Fig. 150 Rear centre head restraint: release
point
.
When transporting people in the back seat,
p
l
ac
e the head restraints of the occupied
seats at a minimum of the next socket up
›››
.
Adjusting the head restraints
–
To set the head restraint higher, grasp the
s
ide
s
with both hands and move it up-
wards, until you see it engage.
–
To set the head restraint lower down, press
the
1
›
›› Fig. 150
b
utton and move it
downwards.
Removing the head restraint
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
–
Unlock the backrest ››› page 159.
–
Move the head restraint upwards until it ar-
rives to the top.
–
Press button
1
›
›
› Fig. 150
, while simulta-
neously pressing on the security hole
2
››› Fig. 150 with a flat
screwdriver a maxi-
mum of 5 mm wide, and remove the head
restraint.
–
Move the backrest until it engages properly
›››
.
Fittin
g the he
a
d restraint
To mount the external head restraints, the
corresponding backrest must be partially fol-
ded forward.
–
Unlock the backrest ››› page 159.
–
Insert the head restraint bars into the
guides until they perceptibly engage. It
»
157
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...