Loading ...
Loading ...
Loading ...
17
The Clean Washer with affresh
®
message will ash at the
end of a wash cycle when the washer/dryer has run 30 wash
cycles. This is a reminder to run the Clean Washer with
affresh
®
cycle.
If the Clean Washer with affresh
®
cycle is not run, the
message will stop ashing at the end of a wash cycle
after running three more regular wash cycles. After 30 more
wash cycles are completed, the Clean Washer with affresh
®
message will again ash at the end of a wash cycle as a
reminder.
CLEAN WASHER CYCLE REMINDER
WASHER/DRYER CARE (cont.)
2. Chlorine Bleach Procedure:
a. Open the washer/dryer door and remove any clothing
or items.
b. Open the single-load dispenser drawer and add
regular liquid chlorine bleach to the “MAX” line in
both the bleach compartment and the fabric softener
compartment. Either traditional or HE chlorine bleach
can be used.
IMPORTANT: Do not use thickened, easy-pour,
or no-splash bleach as excess suds may occur.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer/dryer
damage over time.
c. Close the washer/dryer door and the dispenser
drawer.
d. Do not add any detergent or other chemicals to the
washer/dryer when following this procedure.
e. Select the Clean Washer with affresh
®
cycle.
f. Select the FanFresh
®
option to help dry the washer/
dryer interior after the cycle is complete.
NOTE: The washer/dryer remembers your last option
selection and will use it for future wash cycles until
you deselect that option. While the fan is on, the
washer/dryer door will lock. To unlock the door, touch
POWER.
g. Touch and hold START/PAUSE to begin the cycle.
The Clean Washer with affresh
®
Cycle operation
is described below.
NOTE: For best results, do not interrupt cycle.
Description of Clean Washer with affresh
®
Cycle
Operation:
1. The Clean Washer with affresh
®
cycle will determine
whether clothing or other items are in the washer.
2. If no items are detected in the washer, it will proceed with
the cycle.
a. If any items are detected in the washer, “rL”
(remove load) will be displayed. The door will unlock.
Open washer/dryer and remove any garments from
the washer/dryer drum.
b. Touch POWER to clear the “rL” code.
c. Touch and hold START/PAUSE to restart the cycle.
3. After the cycle is complete, leave the door open slightly to
allow for better ventilation and drying of the washer/dryer
interior.
WASHER/DRYER CARE (cont.)
Cleaning the Dispensers
After using the Clean Washer with affresh
®
cycle, you may
nd some residue buildup in the washer/dryer’s dispensers.
To remove residue from the single-load dispenser, remove
the drawer and wipe the surfaces with an affresh
®
Machine
Cleaning Wipe or a damp cloth and towel dry either before
or after you run the Clean Washer with affresh
®
cycle. Use
an all-purpose surface cleaner, if needed.
To remove residue from the Load & Go™ bulk dispenser,
lift the handle on the dispenser housing and pull to remove
it from the washer/dryer cabinet; then rinse the dispenser
thoroughly with running water. Wipe the outside dispenser
surface with an affresh
®
Machine Cleaning Wipe or a damp
cloth, and towel dry. Use an all-purpose surface cleaner, if
needed.
Replace the dispenser in the washer/dryer cabinet and make
sure that it is correctly seated.
IMPORTANT: Dispensers are not dishwasher-safe.
Cleaning the Outside of the Washer/Dryer
Use an affresh
®
Machine Cleaning Wipe or a soft, damp
cloth or sponge to wipe up any spills. Occasionally wipe the
outside of your washer/dryer to help keep it looking new. Use
an affresh
®
Machine Cleaning Wipe or mild soap and water.
IMPORTANT: To avoid damaging the washer/dryer’s nish,
do not use abrasive products.
Loading ...
Loading ...
Loading ...