Loading ...
Loading ...
Loading ...
35
HOW TO USE
CONTROL LOCK
Use this option to disable the controls.
The washer can only be locked during a
cycle. This feature can prevent children
from changing cycles or operating the
machine. Once set, the controls remain locked and
Control Lock must be turned OFF before the controls can
be used again. Once the washer has shut o, the power
button will allow the machine to be turned ON, but the
controls will still be locked. When the controls are locked,
“CL” will display alternately with the estimated time
remaining.
Press and hold the CHIME button for three seconds to
activate or deactivate the controls.
DELAY START
Once you have selected the cycle and
other settings, press this button to delay
the start of the wash cycle. Each press
of the button increases the delay time by one hour, for
up to 19 hours. Once the desired delay time is set, press
the START/PAUSE button to start the delay time.
CLEAN WASHER
Detergent residue can build up in the wash
drum over time and can lead to a mildewy
or musty smell. The CLEAN WASHER cycle
is specially designed to remove this buildup
using bleach or another cleaner designed specically for
cleaning front load washers. Run the CLEAN WASHER
cycle once a month, or more often under heavy use
conditions or if odor is present.
See complete instructions in the CARE AND CLEANING
section.
Turn ON the washer and press and hold the EXTRA
RINSE button for three seconds. Selecting any other
cycle after CLEAN WASHER has been selected will
cause the CLEAN WASHER cycle to be cancelled.
Fill the bleach dispenser to the MAX line with liquid
chlorine bleach. Do not overll the bleach dispenser.
Overlling will cause the bleach to dispense
immediately.
NOTE:
For other drum cleaning products, follow
the cleaner manufacturer’s instructions and
recommendations. For powdered cleaning products,
add the cleaner to the main wash compartment of
the dispenser drawer. Place tablet cleaners directly
into the drum.
3
Press the START/PAUSE button to start the cycle.
After the cycle has ended, secure the door slightly
ajar with the door magnet. This will promote air
circulation and allow the interior of the machine to
dry. To use this feature, close the door just until it
contacts the door magnet.
NOTE:
Do NOT use this cycle with clothes, and do
NOT add detergent or fabric softener.
AUTO SOAK
Use the Auto Soak option to presoak
garments to help remove dicult spots or
stains on fabric. This option provides a
30-minute presoak prior to the start of the
selected cycle. At the end of the presoak time, the
selected cycle will use the same water.
To use the Auto Soak feature, press the AUTO SOAK
button.
This option saves energy by using cooler
water while increasing the wash and rinse
times to maintain wash performance. This
feature is only available with the
NORMAL/CASUAL and HEAVY DUTY cycles as listed
below.
To use the Energy Saver option, press the ENERGY
SAVER button.
• NORMAL – Hot becomes Warm
• NORMAL – Warm becomes Cold
• HEAVY DUTY – Hot becomes Warm
SPECIAL FUNCTIONS
Loading ...
Loading ...
Loading ...