Loading ...
Loading ...
Loading ...
6
Select options
To select an option, press one of the option
buttons. The field next to the button lights when
the option is activated. The available options depend
on the selected program. Once you have started the
program, the options you selected are saved for the
next time you use the same program.
Temperature
The Temperature option button allows you to select
a higher or lower temperature for the main wash. If
you want to improve dishwashing efficiency, activate
the option for a higher temperature. This option
remains selected until changed.
You can vary the temperature as shown below:
55 °C/ 70 °CHeavy wash:
55 °C/ 65 °CNormal wash:
60 °C/ 65 °CDaily wash:
30 °C/ 60 °CQuick wash:
55 °C/ 60 °CEco wash:
Drying
Press the Drying option button for improved drying
results. The temperature increases during the final
rinse, which improves drying results but increases
program time and energy consumption. If you want a
program with Short dry, press it again and the field
next to the button turns off.
7
Press Start
The display flashes three times with the
remaining time to indicate that the program has
started. Close the door properly otherwise the
dishwasher will not start. The display indicates
if the door is open.
NOTE!
If the machine does not start within 2 minutes of the
last button press, the display returns to showing the
last program run.
Stopping or changing a program
In order not to accidently press a button and cancel
the current program, you must press and hold Stop
for five seconds if you want to change programs after
starting the dishwasher. Add more detergent if the lid
of the detergent dispenser has opened. Then choose
a new program and press Start.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically.
Add the dishes, close the door and the dishwasher
continues the program.
If the dishwasher is turned off using the main
power switch or due to a power failure
If the dishwashing program was not finished, the
interrupted program continues when power is
restored.
NOTE!
During drying, the program is interrupted if the power
is cut or the door is open for more than 2 minutes.
8
After dishwashing
Once the program has finished, "End" appears
on the display.
A buzzer also sounds at the end of the program. See
the section Settings, which describes how to change
this function.
Once the dishwasher has finished, it uses only
standby power. Turn off the dishwasher using the
main power switch if you want to completely cut the
power. Turn off the water supply valve after each use.
Drying
For additional drying the door should be opened 35
mm upon completion of the drying cycle. For more
information refer to the page marked Performance
information in these instructions.
16
Dishwashing
Loading ...
Loading ...
Loading ...