Loading ...
Loading ...
Loading ...
If a tire inflation pressure of 2 bar is not
reached:
1. Switch off the compressor.
2. Pull the connector out of the power socket
inside the vehicle.
3. Unscrew the filling hose from the tire valve.
4. Drive 33 ft/10 m forward and back to dis‐
tribute the sealant in the tire.
5. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your dealer’s service cen‐
ter or another qualified service center or
repair shop.
Stowing the Mobility System
1.
Unscrew the filling hose of the sealant con‐
tainer from the tire valve.
2. Pull the compressor connector out of the
socket inside the vehicle.
3. Unscrew the connection hose of the com‐
pressor from the sealant container.
4. Connect the filling hose of the sealant con‐
tainer previously connected to the tire
valve with the available connector on the
sealant container.
This prevents leftover sealant escaping
from the sealant container.
5. Wrap and store the sealant container in
suitable material to avoid dirtying the cargo
area.
6. Stow the Mobility System back in the
cargo area.
Distributing the sealant
Immediately drive approx. 5 miles/10 km to en‐
sure that the sealant is evenly distributed in the
tire.
Do not exceed the permissible maximum
speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Correcting the tire inflation pressure
1. Stop at a suitable location.
2. Screw the connection hose of the com‐
pressor directly onto the tire valve stem.
3. Insert the connector into the power socket
inside the vehicle.
4. Correct the tire inflation pressure to
2.5 bar.
▷ Increase tire inflation pressure: with the
ignition switched on or the engine run‐
ning, switch on the compressor.
▷ Reduce tire inflation pressure: press
the button on the compressor.
Continuing the trip
Do not exceed the maximum permissible
speed of 50 mph/80 km/h.
Reinitialize the run-flat tires.
Reset the Tire Pressure Monitor TPM.
Replace the nonworking tire and the sealant
container of the Mobility System at the next
opportunity.
Snow chains
Fine-link snow chains
The manufacturer of your vehicle recommends
use of fine-link snow chains. Certain types of
fine-link snow chains have been tested by the
manufacturer of the vehicle and recommended
as road-safe and suitable.
Information regarding suitable snow chains is
available from a dealer’s service center or an‐
other qualified service center or repair shop.
Use
Use only in pairs on the rear wheels, equipped
with the tires of the following size:
▷ 255/50 R 19.
Follow the snow chain manufacturer's instruc‐
tions.
Seite 231
Wheels and tires Mobility
231
Online Edition for Part no. 01402981185 - VI/17
Loading ...
Loading ...
Loading ...