Loading ...
Loading ...
Loading ...
18 19
clean water.
-
ance is ready to make coee again.
NOTE: If descaling is interrupted before completion, the ma-
chine still displays the descaling message and the process must
be begun again from the beginning.
Empty the water tank, rinse with clean water and deliver a cup
of hot water.
Important! FAILURE TO DESCALE THE APPLIANCE REG-
ULARLY INVALIDATES THE GUARANTEE.
Changing coee temperature
To change coee temperature, proceed as follows:
comes on) then press the NEXT button (C3) repeatedly until
the appliance displays “TEMPERATURE HIGH...”;
the required coee temperature;
-
lected;
NEXT (C3) to change other parameters.
Changing the length of time the appliance re-
mains on
The appliance is set by default to go o automatically 30 min-
utes after the last coee has been made.
To change this interval (max. 120 min), proceed as follows:
comes on) then press the NEXT button (C3) repeatedly until
the appliance displays “OFF AFTER...”
hours the appliance remains on.
NEXT (C3) to change other parameters.
Setting water hardness
The descale message is displayed after the appliance has been
operated for a factory set period of time calculated on the basis
of the maximum quantity of limescale which may be contained
in the water used.
The operating period can be extended if required, making des-
caling less frequent by programming the machine on the basis
of the real lime content in the water used.
Proceed as follows:
from its packaging then dip it fully in the water for a few
seconds,
Then remove and wait about 30 seconds (until it changes
colour and forms red squares).
knob (C6) to the
right or left (g. 6);
(C3) repeatedly until the appliance displays “WATER HARD-
NESS 4”;
coincides with the number of red squares on the test strip
(for example, if there are 3 red squares on the test strip,
press the button until “WATER HARDNESS 3” is displayed).
The coee maker is now programmed to provide the des-
cale warning when necessary based on the actual hardness
of the water.
Resetting default values (reset)
If you change the original values, the default values can be reset
as follows:
(C3) repeatedly until the appliance displays “RESET TO DE-
FAULT NO”;
“RESET TO DEFAULT YES”;
“READY” message is displayed.
Washing procedure
This function is available to customer services personnel only.
CHANGING THE LANGUAGE
To change the language, press the CHANGE button (C4) for at
least 5 seconds until the appliance displays the installation mes-
sage in various languages.
Select the required language as described in the section “Using
the appliance for the rst time”.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns! During rinsing, a little hot water
ows from the coee spouts. Avoid contact with splashes of
water.
To turn the appliance o, turn the knob (C6).
The appliance performs the rinse cycle then goes o.
Loading ...
Loading ...
Loading ...