Loading ...
Loading ...
Loading ...
sharkclean.comsharkclean.com
If the robot has no charge and cannot return to the
charging dock, place it on the dock manually.
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If your robot doesn’t return to the dock, its charge
may have run out.
CHARGING THE SHARK ION™ ROBOT
IMPORTANT: The Shark ION Robot has a pre-installed rechargeable battery. Battery must be fully charged
before using.
To charge, the Power button on the side of the robot
must be in the ON position (I).
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
aligned with the dock by leaving a gap of half an inch between the dock face and the front of the robot. To ensure the robot
is docked correctly, refer to the Charge Indicator Lights section.
CHARGING THE SHARK ION™ ROBOT
NOTE: If the low charge light is blinking red, there is not enough charge for the robot to return to the dock. Manually
place the robot on the dock, leaving a half-inch space between the front of the robot and the face of the dock.
TIP: To preserve battery life, turn o the power switch if robot will not be used for a long period of time. Unit should be
recharged at least once every three months.
Clean
Max
Dock
CHARGE INDICATOR LIGHTS
The blue charge indicator lights show how much charge is remaining.
While the robot is charging, all three blue LED lights will cycle. When charging is complete, all three blue
lights will illuminate steadily.
If the robot is idle and away from the charging dock for 10 minutes, it will enter Sleep Mode, and the lights
will turn o.
If all the indicator lights are o, then the robot is in Sleep Mode, the power switch is turned OFF (O) or there
is no charge remaining. Turn the power switch ON (I). Press any button to ensure robot is not in Sleep Mode.
If all indicator lights remain o, there is no charge. Place the robot on the dock, leaving a half-inch space
between the front of the robot and the face of the dock. When the robot is docked correctly and begins to
charge, it will beep and the charge indicator lights will cycle.
Low ChargeMid ChargeNearly FullFull Charge
Low ChargeMid ChargeNearly FullFull Charge
Low ChargeMid ChargeNearly FullFull Charge
In Use
While
Charging
No Charge
or O
USING THE SHARK ION™ ROBOT
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the Clean button on the robot
or on the mobile app. To stop the robot before it finishes cleaning and
automatically returns to the dock, press the button again.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
Loading ...
Loading ...
Loading ...