Loading ...
Loading ...
Loading ...
POD HEADLIGHT REPLACEMENT
When servicing a halogen lamp, avoid touching the lamp with bare fingers. Oil
from your skin leaves a residue, causing a hot spot that will shorten the life of the
lamp. If fingers do touch a lamp, clean it with denatured alcohol.
CAUTION
Hot components can cause burns to skin. Allow lamps to cool before servicing.
1. Remove the screws retaining the
front half of the pod assembly.
2. Remove the front half of the pod.
3. Disconnect the lamp from the main
harness.
4. Remove the lamp form the housing.
NOTICE
If lens housing replacement is required, do so at this time.
5. Install new lamp.
6. Connect lamp to main wiring harness.
7. Install front half of the pod. Torque fasteners until fully seated.
HEADLIGHT ADJUSTMENT
To adjust the front headlights, do the following:
1. Place the vehicle on a level surface with the headlight approximately 25 ft.
(7.6 m) from a wall.
NOTICE
Rider weight must be included on the seat while performing this procedure.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
4. Start the engine and turn the headlight switch to high beam.
122
MAINTENANCE
Loading ...
Loading ...
Loading ...