Loading ...
Loading ...
Loading ...
43
ENGLISH
SPECIFICATIONS
Problem Possible Causes Solutions
Wrinkling
y
Did you remove the load immediately
after it finished?
y
Did you overload the tub?
y
Did you reverse the hot and cold water
inlets?
y
Remove the load immediately after it
finishes.
y
Do not overload the tub.
y
Hot water rinse can cause garments
to wrinkle. Check the inlet hose
connections.
Power is not turned on
y
Is the power cord plugged in properly?
y
Has a house fuse blown, a circuit
breaker tripped, or a power outage
occurred?
y
Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y
Reset the circuit breaker or replace the
fuse. Do not increase the fuse capacity.
If the problem is a circuit overload,
have it corrected by a qualified
electrician.
The door does not open
when the cycle pauses or
finishes
y
Is the temperature in the tub too high?
y
Is the water level in washer high?
y
The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until
the door lock icon disappears from the
display.
y
Allow the washer to complete the
programmed cycle, or Press the Spin
button.
The wash cycle time is
longer than usual
y
Is the washing machine overloaded?
Are other options added to the wash
cycle?
y
This is normal. The washing machine
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
It is musty or moldy in the
tub
y
Has the incorrect detergent been used?
y
Did you clean the tub periodically?
y
Use only HE (High-Efficiency) detergent
recommended for a front-loading
washing machine.
y
See page 36, clean the inside and
outside of the washing machine
periodically.
Banging noise when
washer is filling with
water (Water Hammer)
y
Plumbing in the home moves or flexes
when the water valves in the washer
shut off.
y
Household water supply pressure is
very high.
y
Water hammer is not caused by a
defect in the washer. Install water
hammer arrestors (purchased
separately at hardware or home
improvement store) between the fill
hose and the washer for best results.
y
Adjust household water supply
regulator to a lower pressure or
contact a plumber to have a regulator
installed.
Model WM9000H*A
Description Front-Loading Washer
Electrical requirements 120 VAC @ 60 Hz.
Max. water pressure 20 and 120 psi (138 - 827 kPa)
Dimensions 73.7cm(W) X 85.6cm(D) X 104.5(H), 142cm (D with door open)
29”(W) X 33 ¾”(D) X 41 ¼”(H), 55
15
/
16
” (D with door open)
Net weight 227lb (103kg)
Max. spin speed 1,300RPM
SPECIFICATIONS
Loading ...
Loading ...
Loading ...