Loading ...
Loading ...
Loading ...
Using the Air Conditioner
NOTE: If the air conditioner isturned off,
wait 3 minutes before restarting, This
allows pressure inside the compressor to
equalize Failure to follow these
instructions may cause inefficient
operation.
To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETYINSTRUCTIONSbefore operating this appliance
To begin operating the air conditioner, follow these steps:
1 Plug in the air conditioner. (To prevent electrica! hazards, do not use an
extension cord or an adapter plug )
2. Setthe exhaust vent to the CLOSEDposition..
3 Setthe TEMP Control to the coolest setting
4. Setthe fan control at the highest level.
5 Adjust the louvers for comfortable air flow
6 Once the room has cooled, select the POWERSAVERMODE and/or adjust the
TEMP Control to the setting you find most comfortable.
Air Conditioner Features
VENT
OPEN CLOSE
MODE
OFF
HIGH FAN
COOL ONLY
MED POWER
COOL SAVER
LOW
COOL
TEMP
e 5 e
o o
1 9
COOLER
(some models)
Review the "Air Conditioner Features" section for other settings
The controls featured in this manual are representational of the many models
available Your model may took slightly different
TEMP Control
The TEMP Control serves as the thermostat to set the degree of room
coolness Turn the knob clockwise from t to 9 to increase the cooling
temperature
COOL MODES
When in one of the COOL settings, the air conditioner runs al! the time,
circulating the air Cooling starts only if the room temperature rises above the
coolness level selected on the TEMP Control, and stops once the set coolness
level is reached This setting gives the most even room temperatures
POWER SAVER MODE (some models)
The POWERSAVERMODE can save energy In this setting, the fan will not run
unless the TEMP Control is set colder than the room temperature When the
TEMP Control isset colder than room temperature, the air conditioner wilt
begin to circulate the air in the room Cooling will begin in about 3 minutes
The air conditioner turns off automatically when the room reaches the level of
coolness selected HIGH COOL isfor fast cooling, MED COOL isfor' normal
cooling, and LOW COOL is for-quiet cooling
HEAT (some models)
The HEAT selection provides quiet, efficient circulation of warm air Turn the
selector' to the HEAT setting and set the thermostat to the warmest setting
When the HEAT setting is selected, the thermostat maintains the temperature
by automatically turning the heater on and off in response to room tempera-
ture Once the room iswarm, adjust the thermostat to a cooler setting. The
fan runs continuously to circulate air in the room
FAN COOL
OFF
HiGH H_IGH
LOW LOW
HEAT
HEATControl (somemodels)
MODE
OFF
HIGH FAN
COOL ONLY
POWER
COOL SAVER
LOW
COOL
VENT
TEMP CLOSED l
1 9
COOLER
EXHAUST
Side Air Model Control Panel
HEAVYDUTY
6
Loading ...
Loading ...
Loading ...