Loading ...
Loading ...
Loading ...
10
3. Locate and remove the (2) 4 x 13 mm service screws inside
the range hood blower housing.
NOTE: These are be used to hold the lower chimney cover
up while assembling the range hood canopy to the upper
chimney cover.
4. Slide the lower chimney cover up over the upper chimney
cover until its bottom edge is above the holes on the upper
chimney cover front and back. While holding the lower
chimney cover, install the 4 x 13 mm service screws in
each side of the upper chimney cover. Leave approximately
¹⁄₈" (3 mm) between the head of the screw and the upper
chimney cover. Lower the lower chimney cover to rest on the
top of the screws. These screws will hold the lower chimney
cover up while assembling the range hood canopy to the
upper chimney cover.
5. Move the range hood to its mounting location and
connect the power supply. See the “Make Electrical
Connections” section.
6. Lift the range hood canopy into the approximate
recommended height for the cooktop type and install a
minimum of (4) 5 x 12 mm screws (D) (2 each side) through
the slots in the upper chimney cover and into the mounted
threaded fasteners (F) of the range hood canopy.
7. Adjust the range hood to the desired height. Level the
range hood and tighten the screws using a T20
®
Torx
®
bit.
See “Installation Dimensions” in the “Location Requirements”
section.
NOTE: Final height must be between the recommended
minimum and maximum dimension. The mounted threaded
fasteners (F) are for height adjustments during installation for
approved minimum and maximum distance between the
bottom of the range hood and the top of the cooking surface.
8. Reach inside the range hood cavity and grasp the handle of
the mounting boss. Pull down to align nuts through cutout
holes in the module top cover. Push back into half-slots to
assemble. Tighten (4) nuts using the ½" (13 mm) special tool
or ½" socket and driver with extension.
A. 4 x 13 mm service screws (2)
B. Inside area of range hood blower housing
A. Lower chimney cover (front)
B. Bottom edge of lower chimney cover
C. 4 x 13 mm screws
D. Upper chimney cover
A. Lower chimney cover
B. 4 x 13 mm screws
C. Upper chimney cover
D.
¹⁄₈
" (3.2 mm)
A
B
A
D
C
B
B
A
C
D
A. Ceiling
B. Lower chimney cover
C. Upper chimney cover
D. Mounting screws (4)
E. Range hood canopy
assembly
F. Range hood canopy
mounted thread fasteners
B
A
C
D
E
F
Loading ...
Loading ...
Loading ...