Loading ...
Loading ...
Loading ...
en Installing and connecting the appliance
8
Connect the water drain hose as
follows:
1. Use the spring clip to secure the
water drain hose to the outlet on the
appliance.
Note: Only for appliances with a
separate water drain hose.
2. Second end of the water drain hose
– For models with a pump, attach it
to a waste pipe or hang it in a
wash basin.
Note: The height difference between
the surface on which the appliance
is installed and the drain pipe must
be between 86 and 100 cm,
depending on the product
variant.~ Page 5
– For models without a pump,
secure it in a floor drain.
Notes
– The height difference between
the surface on which the
appliance is installed and the
water drain hose should be no
more than 15 cm.
– If you extend the drain hose, its
total length should be no more
than 3 m. Otherwise, the water
will not be able to drain away
properly.
Electrical connection
:Warning
Risk of electric shock/fire/material
damage/damage to the appliance!
If the appliance is not installed properly,
this may lead to a dangerous situation.
Ensure the following:
■ The mains voltage on your power
socket must match the rated voltage
specified on the appliance
(identification plate). The connected
loads and the required fuse
protection are specified on the
identification plate.
■ The appliance must only be
connected to alternating voltage via
a protective contact socket that has
been correctly installed. This plug
socket must be freely accessible at
all times.
■ The mains plug and the protective
contact socket must match and the
earthing system must be correctly
installed.
■ The installation must have an
adequate cross section.
■ The mains plug must be freely
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(all pole disconnection) must be built
into the permanent installation in
accordance with electrical
installation regulations.
Loading ...
Loading ...
Loading ...