Loading ...
Loading ...
Loading ...
part must be placed outside the lower part. Do not connect the rangehood exhaust to the same conductor
used to circulate hot air or for evacuating fumes from other appliances gen erated by other than an electrical
source. In the case of assembly of the appliance in the exhausting version prepare the hole for evacuation of
the air.
Warning: Failure to install the screws or xing device in accordance with these instructions
may result in electrical hazards (see technical data if supplied).
Installation
The following instruction should be followed to carry out the correct installation of the rangehood .
1) Mounting of the rangehood on the lower side of the cupboard.
2) Selection of the version (extraction or ltration)
Mounting the rangehood on the lower side of the cupboard. This appliance must be tted to a cupboard or
other suitable support. For xing use 4 screws suitable for the cupboard, using the hole in Fig.1. When mount-
ing align the front of the rangehood to the door of the cupboard and regulate the L wall spacer through the
screws marked P (Fig. 2). The rear of the appliance must then align with the cupboard.
Extraction through an outside wall
The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in
accordance with the standards in use and connect it to ange B (Fig.3-4).
Recirculation
To transform the rangehood from the extraction version to the re circulating one ask your supplier for an acti-
vated carbon lter. The activated carbon lter cleans the air of the room. This lter is not washable or re-usable
and must be substituted at least every 4 months. Saturation of the activated carbon depends on how often the
appliance is used, the type of kitchen and how regularly the grease lter is cleaned. The lter must be tted to
the motor in the centre of the fan grille by twisting it by 90 degrees until it is gripped securely. Remove the grill
(G) g. 2 to carry out this operation. The clean air is returned into the room through a connecting tube passing
inside the cupboard and connected to the ring B (Fig.1).
- 7 -
Loading ...
Loading ...
Loading ...