Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
60
Faults and what to do about them.
Faults Cause/remedy
Water is leaking from the
machine.
■ Attach the drain hose correctly or replace it.
■ Tighten the threaded joint on the supply hose.
The appliance is not filling
with water.
Detergent is not being
dispensed.
■ Have you pressed the A button?
■ Is the tap turned on?
■ Could the filter be clogged? Clean the filter. ~ Page 57
■ Is the supply hose kinked or trapped?
The door will not open. ■ The safety function is activated. Stop the programme? ~ Page 47
■ Is the E childproof lock activated? Deactivate. ~ Page 46
■ Is $ selected (Rinse Stop = no final spin)? ~ Page 47
■ Can the door only be opened by the emergency release? ~ Page 58
The programme does not
start.
■ Have you pressed the A or Finished In button?
■ Is the door closed?
■ Is the E childproof lock activated? Deactivate. ~ Page 46
The drum briefly jerks or
judders after the
programme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder
briefly when the wash programme starts.
The water is not draining. ■ Is $ selected (Rinse Stop = no final spin)? ~ Page 47
■ Clean the drain pump. ~ Page 56
■ Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not
satisfactory.
Laundry wet/too damp.
■ Not a fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
■ Is Reduced Ironing selected (depending on the model)? ~ Page 40
■ Is the selected speed too low? ~ Page 38
The appliance restarts the
spin cycle several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■ Not a fault – the unbalanced load detection system is adjusting an
imbalance by repeatedly redistributing the laundry.
■ Not a fault – the foam detection system is active – a rinse cycle has been
switched on.
The length of the
programme changes
during the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Water remaining in the
care-product
compartment i .
■ Not a fault – the effectiveness of the care product is not affected.
■ Clean the insert if necessary. ~ Page 56
Loading ...
Loading ...
Loading ...