Loading ...
Loading ...
Loading ...
Faults and what to do about them. en
59
Information on the display panel
Display Cause/remedy
Pause: Reload is not
possible
Temperature or water level is too high. Press the A button to continue the
programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Temperature or water level is too high. Press the A button to continue the
programme.
The door cannot be
locked; please open
the door again, then
close it and select the
A button
■ Laundry may be caught. Open and close the door again and press the A
button.
■ If necessary, push the door closed or remove some laundry and then push it
closed again.
■ If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Turn on the tap ■ Turn the tap on fully,
■ Supply hose kinked/trapped,
■ The water pressure is too low. Clean the filter. ~ Page 57
Clean the drain pump ■ The drain pump is blocked. Clean the drain pump. ~ Page 56
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 57
AquaStop has been
activated. Please call
the after-sales
service
Not applicable on models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button. ~ Page 53
Water cooling To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.
Drum care
information:
This instruction reminds you to run the Drum Clean 90 °C programme or a 60 °C
programme to clean and care for the drum and the outer tub.
Notes
■ Run the programme without laundry.
■ Use washing powder or a detergent that contains bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■ Switch reminder information on/off. ~ Page 53
} Remote start selected.
| Off: Wi-Fi is switched off and the appliance is not connected to your home network.
Flashing: The appliance is trying to connect to your home network.
Lit: Wi-Fi is switched on and the appliance is connected to your home network.
Other displays
Error E:XXX
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
Loading ...
Loading ...
Loading ...