Loading ...
Loading ...
Loading ...
Installation and connection aus
47
Electrical connection
■ Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing 92.
■ The socket must be near the
appliance and freely accessible
following installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side to
satisfy the relevant safety
instructions.
■ The connection may be modified
by technicians only.
■ A power cord extension may be
purchased from customer service
only.
■ Use only a residual current operated
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
■ The appliance features a water
damage protection system. Please
note the system will function only
when the power supply
is connected.
Removal
Also observe
the sequence of worksteps here.
1. Disconnect the appliance from the
power supply.
2. Turn off the tap.
3. Undo the waste water and drinking
water connection.
4. Loosen fastening screws for the
furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.
Transporting
Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF switch (.
4. Select programme with the highest
temperature.
The estimated programme duration
is indicated on the display window at
the top @.
5. Press START button h.
6. Close the door.
Programme sequence starts.
7. Open the door after
approx. 4 minutes.
8. Press START button h until
“Program was terminated”/“Ready in
one minute.” is indicated at the top
of the display window @.
9. Close the door.
10. Open the door after approx. 1
minute.
The display window at the top @
indicates; “Finished”.
11. Switch off ON/OFF switch (.
12. Turn off the tap, disconnect supply
hose and drain water.
Note: Transport appliance upright only.
This prevents residual water from
running into the machine control
and damaging the programme
sequence.
Protection against frost
Pr ot ec t i on agai nst frost (Empt yi ng the appl i anc e)
If the appliance is in a room where
there is a risk of frost (e.g. holiday
home), empty the appliance completely
(see Transportation).
6XEMHFWWRFKDQ
J
HV
Loading ...