Loading ...
Loading ...
Loading ...
aus Fault, what to do?
38
A different error code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
error code.
Refill indicator for rinse-aid
H is lit.
No rinse aid. Refill rinse aid.
Refill indicator for rinse-aid
H is not lit.
Refill indicator switched off. Activation/deactivation.~ "Rinse aid"
on page 16
There is still enough rinse aid
available.
Check refill indicator, levels.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1R is blocked.
Clean filters and area underneath.
Program has not ended yet. Wait until programme ends or reset.
Utensils not dry. No or too little rinse aid in the
dispenser.
Refill rinse aid.
Programme selected without
drying.
Select programme with drying.
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used
has a poor drying performance
Use different combination detergent with
better drying performance. Use of rinse
aid also increases the drying performance.
ExtraDry to increase drying not
activated.
Activate ExtraDry.
Utensils were removed too early
or drying process had not ended
yet.
Wait until program ends or wait until 30
min after program ends before removing
utensils.
The eco rinse aid used has a
limited drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...