Loading ...
Loading ...
Loading ...
10 11TROLLEY ASSEMBLYTROLLEY ASSEMBLY
TROLLEY ASSEMBLY
Step 10
2 x ‘E’, 4 x ‘F’, 2 x ‘G’
Attach the Cylinder-Hook on right hand side of BBQ.
Step 11
Connect barbecue to the cylinder and carry out a leak-test.
Refer to Leak Testing Procedure on page 6.
NOTE: When in operation, keep 450mm (18”) clearances
from combustible materials.
TROLLEY ASSEMBLY
Step 5
4 x ‘D’, 8 x ‘F’, 4 x ‘G’, 10 x ‘H’, 10 x ‘I’, 20 x ‘J’
Verify magnet is in place (except for 5 Burners), and attach
the bottom panel. Ensure the folds are facing up, and the
magnet down and to front.
Step 6
Fit door guide to bottom of the door as shown below
Step 7
Two of the four casters have stops. Ensure these are fitted
at the front of the unit.
Step 8
Assemble the rubber ring to the hole in the side panel
Step 9
4 x ‘K’
Turn the assembled barbecue upright, attach handles to
doors, insert the hinge rod to the door, and assemble doors
to trolley.
It recommend to install the hinge rod at the top first, then
bend it slightly into it’s position at the bottom.
General
This barbecue is to be mounted onto a mobile trolley.
The Trolley is packed in a separate carton. Please refer to
the Trolley instruction booklet for assembly of the trolley, and
barbecue mounting.
Once the barbecue had been properly installed on the trolley,
please check the following:
1. Hood is secured by 4 screws to barbecue’s body, and
operating correctly.
2. All burners are in place correctly.
3 Vaporizers are installed above burners, but under the
Grill (not required under the Plate).
Ensure any protective film on the vaporizers is removed
prior to use
4 Cooking surfaces (Grill and Plate) are clean, and
installed over the burners.
Loading ...
Loading ...
Loading ...