User Manual - Page 3

For BDMG424SA. Series: 1000ES ,1000E
Also, The document are for others Beefeater models: BDMG524SA, BDMG520SA, BDMG524BA, BDMG520BA, BDMG420SA, BDMG424BA, BDMG420BA, BDMG324SA, BDMG320SA, BDMG324BA, BDMG320BA

Loading ...
Loading ...
4 5SAFETY
IMPORTANT SAFETY INSTRUCTIONS
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
WARNING
WARNING
Failure to follow these instructions and observe the
warnings provided in this operations manual could result in
fire, explosion or burn hazard, which could cause property
damage, personal injury or death.
Gas vapour is highly explosive and can cause serious bodily
injury or damage to property if allowed to accumulate in a
confined space and ignited.
This appliance must not be installed under or on any
combustible material. Minimum clearance from combustible
materials to all sides of the appliance is 450mm (18”).
These instructions must be left with the owner.
NOTE:
1. Do not use gas other than the type specified on the
Data Plate.
2. The appliance is designed for use by adults, keep
children away from the barbecue at all times.
3. Use only on a flat, level, stable non-combustible surface.
Do not use this appliance on any surface that can burn
or melt.
4. When in use, gas cylinder should be kept at designated
mountings of barbecue, and supply hoses kept away
from any hot surfaces.
5. To prevent accidental fires, before using the appliance
ensure that there is no apparent damage to hose and
regulator and all joint connections are in good order and
not leaking.
6. Use a soapy water solution on all joints in order to check
for leaks. If bubbles appear, it indicates that there is a
leak and the appliance must not be used.
7. LPG cylinder, regulator and hose must comply with
national standards.
8. Do not move or attempt to move the appliance while in
operation.
9 Do not operate this appliance before leak checking
hoses and gas cylinder connection.
Move the appliance during use.
Obstruct any ventilation of barbecue or the cylinder.
Allow the flexible gas supply hose or any electrical cord
to come in contact with hot surface of the appliance.
Allow children to operate this appliance.
Use charcoal or any other solid fuel in this appliance.
Disconnect any gas fittings while the appliance
is operating.
Use a rusty or dented gas cylinder or cylinder with a
damaged gas valve.
Fill the gas cylinder beyond 80% capacity.
Touch some accessible parts, other than the ones meant
for handling. They may be hot.
Do
Spanner tighten all gas fittings as per instructions.
Check all gas hoses and line connections for damage,
cuts or cracks each time the appliance is about to
be used.
Always leak test with a solution of soapy water.
Check main opening, throat and venturi to each burner
and pilot flame tube regularly for insect nests (eg. wasp,
ants or spiders). Nests are dangerous and must be
cleaned out thoroughly.
Visually check burner flames to confirm lighting.
Use your barbecue only on a level surface.
Attend barbecue whilst cooking food.
Preheat the barbecue for up to 10 minutes.
After cooking turn barbecue to high for up to 10 minutes
to burn off excess grease.
Let the barbecue cool before replacing any lid or cover.
Regularly replace foil material in grease/drip tray.
Keep children away from barbecue at all times.
Have the gas cylinder filled by an authorised
LPG supplier.
Refer to this instruction manual if in doubt concerning
assembly, installation, or operation.
Use protective gloves when handling hot components.
Close the gas cylinder valve after each use.
Clean the grease/drip tray regularly and clean the
appliance at least twice annually.
Always remove any lid or cover off the appliance
before lighting.
Carefully follow the instructions relating to the hose/
regulator connection.
Keep the barbecue area free from combustible
materials, gasoline, flammable liquids or vapours.
To the installer
For fixed installations, in Australia refer also to the
requirements of AS/NZS5601, local authority, gas,
electricity, and any other relevant statutory regulations.
For fixed installations, refer to AS/NZS5601 for pipe
sizing details.
Consult other trades. Where required, consult a
bricklayer or an electrician for parts of the installation
that could have an effect on these areas.
Allow a 20mm gap from back of barbecue body for
ventilation and air access.
Test appliance for correct operation before leaving, and
instruct user on its use.
If correct operation cannot be achieved, disconnect
barbecue from gas supply, and contact your nearest
BeefEater dealer.
Please only use BeefEater supplied hose(s) to connect
this appliance. Natural Gas conversion kits are available
from your nearest BeefEater dealer.
Australia only (applies to all gas types) : Where a mobile
appliance is to be connected to a fixed gas supply via a
flexible hose connection, a retaining tether of adequate
strength shall be fixed to the appliance and be suitable
to be fixed to the wall within 50mm of each connection
point. The length of the tether shall not exceed 80%
of the length of the hose assembly. In this way, if the
barbecue is accidentally moved, the tether stops the
barbecue from stretching the hose.
Do not
Lean over barbecue when lighting.
Leave cooking food unattended.
Delay lighting burners after turning gas on.
Spray or store aerosols in vicinity of barbecue whilst
in operation.
Place articles on or against this appliance
Store combustible materials, gasoline or flammable
liquids or vapours within 450mm (18”) of barbecue.
Use caustic based cleaning agents on the barbecue.
Operate barbecue with any cover on.
Use plastic or glass utensils on the barbecue.
Operate barbecue in strong winds.
Attempt to dismantle control valves.
Attempt to dismantle or adjust regulator.
Test for gas leaks with a naked flame.
Store gas cylinder indoors, or in any enclosed area.
Lay the gas cylinder down. Always keep it upright.
Use barbecue indoors.
Expose hose to direct sunlight.
Modify the construction of this appliance or the size of
any burner or valve orifice.
TIPS & INFORMATION
IMPORTANT
Should the appliance go out for any reason, turn off all
control knobs and the cylinder gas valve. Wait 5 minutes
before attempting to relight the appliance.
If a grease or fat fire should occur, immediately turn off
all control knobs and the gas cylinder valve until the fire
is out. Remove all food from the appliance.
A leak test must be carried out prior to using the
appliance for the first time and whenever the gas
cylinder is refilled or whenever the gas hose and
regulator have been disconnected from the gas cylinder
or appliance.
Loading ...
Loading ...
Loading ...