Loading ...
Loading ...
Loading ...
31
The Check drain indi-
cator light up.
Water has not drained
completely.
Drain hose is blocked. Check drain hose.
~ Maintenance of drain hose; Page 29
Check drain hose connection conditions.
Drain hose is leaking: is not
screwed on the tight at both ends,
or rubber not placed in hose.
Check the drain hose, be sure that it is on the dryer
securely with the clamp in place; may need to replace
the drain hose if leaking continues.
Water is leaking out. Dryer is not leveled. Level the dryer.
~ Leveling the dryer; Page 14
The heat exchanger seal is dirty. Clean the heat exchanger seal.
~ Cleaning the heat exchanger; Page 28
Program terminates
shortly after starting.
Ambient temperature greater than
41°F/5°C.
Ventilate the room.
Laundry is not loaded. Load the laundry.
~ Loading the laundry; Page 25
Load too small for selected pro-
gram.
Use time program.
~ Program selection table; Page 20
Loaded laundry dry. Check the loaded laundry. If it is dry, open the door,
remove laundry and turn program selector to Off.
The door opens by
itself.
The door not closed properly. Close the door until a click is heard.
Creasing. Laundry load exceeded.
Unsuitable program selected.
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to Off.
~ Program selection table; Page 20
Drying result is not sat-
isfactory (laundry feels
too damp).
Warm laundry may feel damper
than it really is.
Remove items of laundry immediately after the end of
the program and turn the program selector to Off.
The selected program does not suit
the load.
Use another drying program or, in addition, select the
time program.
~ Program selection table; Page 20
Dryness level is not adjusted. Use Dry Level to adjust the dryness level.
~ Dry Level; Page 21
Fine layer of limescale on the
humidity sensors.
Clean the moisture sensors.
~ Cleaning the moisture sensors; Page 29
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
See the problem(s) mentioned in this table.
Laundry is too wet. Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer and switch on again.
Drying time too long. Lint filter is dirty. Clean lint filter.
~ Cleaning the lint filter; Page 27
Insufficient supply of air.
Air inlet possibly blocked.
Ensure that air can circulate.
Do not obstruct the air inlet on the front of the dryer.
Ambient temperature higher than
95°F/35°C.
Ventilate the room.
Program does not start
Finished in (remaining)
time is displayed.
Program ending time has been
selected and activated.
Drying cycle will begin at proper time to complete at
the selected Finished in time.
Program does not start
- D symbol light up.
Childproof look is activated. Deactivate Childproof look.
~ Childproof lock; Page 26
Problem Possible cause(s) Solution(s)
Loading ...
Loading ...
Loading ...