Loading ...
Loading ...
Loading ...
12
■ Is the dryer located in a room with temperature below
45ºF (7ºC)?
Proper operation of dryer cycles requires temperatures above
4
5ºF (7ºC).
■ Is the dryer located in a closet?
Closet doors must have ventila
tion openings at the top and
bottom of the door. The front of the dryer requires a minimum
of 1" (25 mm) of airspace, and, for mos
t installations, the rear
of the dryer requires 5" (127 mm). See the Installation
I
nstructions.
■ Has the Air Only modifier been selected?
Select the right temperature for the types of garments being
drie
d. See “Additional Features.”
■ Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Cycle time too short
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
■ Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the
dryer
.
Change the dryness level setting
on Auto Cycles. Increasing
or decreasing the dryness level will change the amount of
drying time in a cycle.
Do not use a drying rack with an Auto Cycle.
Lint on load
■ Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
■ Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the
beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments. Do not use fabric softener sheets with
st
eam cycles.
Drum stains are caused by dyes in
clothing (usually blue
jeans). These will not transfer to other clothing.
Loads are wrinkled
■ Was the load removed from dryer at the end of the cycle?
■ Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
■ Have you recently been painting, staining, or varnishing in
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
■ Is the dryer being used for the first time?
The new electric heating element on electr
ic models may have
an odor. The odor will be gone after the first cycle.
Loading ...
Loading ...
Loading ...