Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
38
6. Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.2). Remove the
control panel (see 1.1). Remove the centre cover strip
(5 screws, 2 top, 2 bottom, 1 in middle). Remove the
two countersunk screws (1 each side) securing the grill
hinge arms to the front of the grill chamber.
Note: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order, ensuring that the gasket is
tted between the hinge arm and the front of the grill
chamber.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element. Lift the element out carefully, disconnecting
the leads from the element terminals (noting their
position). If it is not possible to disconnect the leads in
this way, pull the cooker forward to gain access to the
rear, remove the screws securing the electric cover to
the back sheet, remove the cover and disconnect the
terminals from the rear.
Fit the new element and reassemble in reverse order.
Check the operation of the grill.
6.2 To Replace an Oven Door
Open the oven door. Support the door and remove the
two screws securing the upper hinge and gasket to the
cooker front (Fig. 8.3). Remove the door from the lower
hinge by lifting slightly and moving outwards (Fig. 8.4).
The door is heavy, so take care.
Reassemble in reverse order.
6.3 To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 8.5). Loosen the bottom
hinge xing screws and use the notch and a at bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 8.6).
Retighten the hinge screws.
6.4 To Replace the Main Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
xing screws from the door sides – two each side
(Fig. 8.7).
Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing
the two retaining nuts. Fit the door handle to the new
panel. Fit the panel to the door. Reassemble in reverse
order.
6.5 To Change the Main Oven Door Latch
Remove the outer door panel (see 12). Remove screws
‘B’ that hold the latch assembly to the inner door panel
(Fig. 8.8). Fit the new catch and reassemble in reverse
order.
Verify the door operation.
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0007 Oven door hinge adjustment 2
ArtNo.320-0006 Oven door hinge adjustment 1
Eect of hinge adjustment – exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
ArtNo.320-0004 Oven door keep
ArtNo.320-0003 Oven door latch
B
Fig. 8.3 Fig. 8.4
Fig. 8.5
Fig. 8.6
Fig. 8.7
Fig. 8.8 Fig. 8.9
Loading ...
Loading ...
Loading ...