Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
35
8. Servicing
Disconnect the cooker from the electricity supply
before servicing, particularly before removing any
of the following: control panel, side panels, ceramic
hob, or any of the electrical components or cover
boxes.
Before reconnection, check that the appliance is
electrically safe.
1. Panels
1.1 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Removing the Control Panel
Pull o all the control knobs and remove the xing
screws underneath the control panel.
The control panel will drop down slightly. It is held
at the top by two holes in the top edge, one at each
end, that locate on the tags on the inner panel. Lift the
control panel clear of the tags and pull forwards, taking
care not to damage or strain the wiring.
1.2 To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull the cooker
forward. Remove the 4 retaining screws for each panel
(1 at the front base, 1 on the top and 2 at the rear).
Reassemble in reverse order.
2. Hotplates
2.1 To Lift up the Ceramic Hob
Disconnect from electricity supply.
Pull o the push t control panel end caps at each end
and remove the end xing screws under the end cap.
Remove the lower front retaining screws (one each side)
situated beneath the lower edge at the front corners of
the side panels.
Swing the side panels to gain access to the hob xing
screws (1 each side) at the top front of the side uprights.
Remove these screws.
Lift up the ceramic hob at the front and prop into
position with a non-metallic prop.
CAUTION: The ceramic hob material is much more
sensitive to scratches on the underside than the top.
Take care not to touch or scratch the underside of the
ceramic as this will weaken the material and cause the
top to shatter.
3. Controls
3.1 To Replace the Light Switch
Disconnect from electricity supply.
Remove the control panel (see 1.1).
Note: The old switch may be destroyed during removal.
Remove the old switch from its bezel by gripping the
switch body behind the control panel and twisting
sharply. Remove the switch bezel by folding back its
locking wings and pushing forward. Fit the new bezel to
the control panel by rst lining up the raised key on its
body with the cut-out in the control panel and pushing
it in from the front.
Assemble the new switch to the bezel by lining up the
key sections and pushing home. Fit the new button by
pushing in from the front. Replace the Control Panel in
reverse order and test for correct operation.
3.2 To Remove the Electronic Timer
Disconnect from electricity supply.
Remove the control panel (see 1.1). Pull o the timer
control button(s).
Remove the timer/mounting bracket assembly from the
control panel by removing the xing screws.
Remove the timer from its mounting bracket by
depressing the plastic lugs on the timer case, at the
same time pulling the unit forward. Reassemble in
reverse order. When replacing the leads, refer to the
wiring diagram in this manual. Check the operation of
the timer.
Loading ...
Loading ...
Loading ...